Outback Armour front heavy duty bump stops drop straight into the factory front locations on Toyota Hilux N80 models from 2015 onwards and handle the hard hits when the suspension tops out. The kit runs a 60mm tall progressive rubber cone on each side so you can tackle washouts and speed humps without the harsh metal to metal feel at full compression. Two units come in the kit so the front end stays balanced. The gear uses dense rubber and pressed steel caps around 3mm thick with multi fit hardware cut to suit the Hilux chassis points. High tensile bolts in lengths close to 25mm and 50mm give solid clamping into the mounts. This setup is a smart buy if your touring rig carries bar work and extra weight over the nose and you want bump control that is built tough for Australian back roads and job sites.

• Heavy duty front bump stop kit for Toyota Hilux Generation 8 (N80) 2015+
• Uses extended progressive rate rubber bump stops to manage suspension compression
• Each bump stop measures approximately 60mm in height
• Multi-fit configuration to suit factory front bump stop mounting points
• Dense rubber construction for repeated high load impacts
• Pressed steel caps around 3mm thick spread load into chassis brackets
• Supplied with high tensile mounting bolts in short and long lengths
• Kit includes two bump stop assemblies to service both sides of the front axle
• Helps reduce harsh metal-to-metal contact at full suspension travel
• Manufactured by Outback Armour for 4x4 and touring applications

Q: Is this kit for the front or rear of the Hilux?

This kit is for the front only. The bump stops and hardware are sized to suit the factory front bump stop positions on Toyota Hilux N80 models from 2015 onward. Rear bump stops on these vehicles use a different layout and dimensions. If you need rear bump control you will need a separate rear specific kit.

Q: How many bump stops come in one Outback Armour kit?

One kit includes two bump stops. That covers both front sides on a single Hilux N80. Each bump stop comes with its own cap and mounting hardware. You only need to order one kit per vehicle front end. Ordering a second kit would give you a spare pair.

Q: What type of material are the bump stops made from?

The bump stops in this kit are made from rubber. The rubber is moulded into a progressive profile that changes rate as it compresses. The rubber is bonded to a steel cap that spreads load into the chassis bracket. This combination is common on heavy duty 4x4 suspension gear.

Q: Will these fit a pre-2015 Hilux model?

These bump stops are listed for Toyota Hilux Generation 8 N80 models from 2015 plus. Earlier generations run different chassis brackets and bump stop layouts. For a pre 2015 Hilux you will need a kit listed specifically for that series. Always match the kit to your exact model and year before ordering.

• Suits Toyota Hilux Generation 8 (N80) 2015+ front suspension
• Location: front axle bump stop positions
• Configuration: multi-fit style using supplied bolts and plates
• Intended use: replacement or upgrade for factory front bump stops