Tycab Orange 3 mm Single Core cable in a 30 m spool gives you enough wiring to sort most small 12V jobs front to back. The 10 A rating and copper core with 14 strands at 0.32 mm suits lights, USB sockets and low‑draw gear in the ute, wagon or camper. The bright orange sheath stands out in looms so you can track accessory circuits quickly when you are fault‑finding on the road. The insulation is rated to 90 °C, so it handles typical Aussie under‑bonnet and interior temps without breaking down. The 3 mm conductor size gives a good balance between flexibility and voltage drop on runs up to the full 30 m. The single core layout matches standard crimp lugs and joiners you already carry in the kit. Grab this spool as a smart buy for general 12V wiring jobs from coast to campsite.

• Tycab orange 3 mm single core cable
• Supplied in a single 30 m spool
• Rated to carry up to 10 A
• Copper conductor with 14 x 0.32 mm strands
• Insulation temperature rating up to 90 °C
• Bright orange sheath aids cable identification
• Suitable for low-voltage automotive-style circuits
• Flexible construction for routing in tight spaces
• Single core design suits standard crimp terminals
• Ideal for general 12V accessory wiring runs

Q: What voltage systems is this cable suited to?

This cable is suited to low-voltage automotive-style systems. It is commonly used on 12V and 24V setups where the current does not exceed 10 A. The 3 mm conductor and insulation are sized for accessory and light-duty circuits rather than mains power. Always match the cable to the system voltage and current limits set by your installer or auto electrician.

Q: Can I bury this cable directly in the ground?

This cable is not intended for direct burial. It is automotive-style single core cable meant for protected routing in vehicles, trailers or enclosed installations. Direct burial usually needs special insulation and mechanical protection. For fixed underground work, use cable that is specifically rated and approved for that purpose.

Q: Is the 30 m length supplied as one continuous piece?

Yes, the 30 m is supplied as a single spooled length. That continuous run helps reduce joins, which are common failure points in mobile setups. You can cut shorter pieces from the spool to suit each circuit. Any joins you add should be made with suitable connectors and protected from moisture and abrasion.

Q: Can this cable be used under the bonnet of a vehicle?

Yes, within its 90 °C temperature rating and 10 A current limit. The insulation rating of 90 °C covers most engine-bay ambient temperatures in normal use. Route the cable away from exhausts and sharp edges to avoid damage. Use proper conduit or split tubing where extra mechanical protection is needed.