The Oceansouth 9" stainless handrail gives you a solid grab point across a short 229mm run, handy near steps, ladders or side decks. The 22mm diameter bar feels right in the hand when the boat leans under a 20–25 knot breeze or chop. The kit comes with hardware matched to the nylon bases so you can bolt it down once and get on with launching and retrieving.

The rail is 316 grade stainless steel with a mirror finish, built tough for saltwater and regular hosing with mains-pressure water. The marine-grade nylon bases sit between the metal tube and your gelcoat or alloy, helping spread load over the mounting area. The compact 229mm size suits smaller cockpits and cabin tops that do not have room for a long bar. It is a smart buy if you want tidy, low-profile grab points that handle Aussie marine conditions.

• Oceansouth stainless steel handrail for marine use

• Overall handrail length of 9" (229mm)

• Tube outside diameter of 22mm for secure grip

• 316 grade stainless steel tubing with mirror finish

• Marine-grade nylon bases support each end of the rail

• Includes matching mounting hardware in the pack

• Compact size suits cockpits, cabin entries and ladder tops

• Suitable for installation on fibreglass, alloy or timber decks

• Ideal as an extra grab handle on small boats

• Corrosion-resistant materials for long-term saltwater exposure

Q: Can this Oceansouth 9" handrail be used inside a cabin as well as on deck?

Yes, it can be mounted inside a cabin or on open deck areas. The 316 stainless tube handles humid enclosed spaces as well as salt spray outside. The marine-grade nylon bases sit neatly on timber, fibreglass or alloy surfaces. Just make sure the surface is flat enough for the bases and use a sealant where water might track through the fixing holes.

Q: What tools are typically required to install this handrail?

Basic hand tools such as a drill, drill bits and a screwdriver are usually sufficient. You will need to mark and drill the mounting holes to suit the included hardware. A countersink bit can help tidy the holes in fibreglass or timber. Always check behind the mounting surface for wiring or plumbing before drilling to avoid damage during fitment.

Q: Is the 316 stainless steel suitable for use in saltwater environments?

Yes, 316 stainless steel is commonly used for marine applications in saltwater. This grade contains molybdenum, which improves resistance to pitting from chlorides found in seawater. Regular rinsing with fresh water after trips still helps reduce surface staining. Inspect fittings periodically so you can address any wear around the mounting points.

Q: Do I need backing plates under the deck for this handrail?

Backing plates are recommended on thinner or weaker mounting surfaces. A backing plate spreads the load from the handrail across a larger area. This can help prevent cracking on fibreglass or deforming on light alloy panels. Many boat owners use stainless or aluminium plate offcuts cut slightly larger than the nylon bases to do this.

• Suits installations on flat or gently curved marine surfaces only

• Handrail mounts via the two integrated marine-grade nylon bases

• Installer must drill mounting holes to match supplied hardware

• Use appropriate marine sealant at mounting points to help protect the deck

• Check clearance to allow for the 22mm tube diameter and 9" (229mm) length

• Fitment should be carried out using standard marine hand tools by a competent person