The Narva Ultima 215 LED Black Bezel steps in when the original ring cops a rock or gets scratched on a tight track. The gloss black finish is matched to the Ultima 215 LED High Powered Driving Light so your 215 mm lamps still look like a set. The screw holes line up with the standard 71740 housing so you can swap the ring in the shed before the next run.

The bezel uses a solid circular profile sized for the Ultima 215 body and is shaped to sit flush against the light face without fouling the lens. The gloss black surface stands up to sun, dust and regular washing that comes with touring week after week. You keep the same light output and beam pattern because the bezel follows the original 215 mm diameter and depth. For anyone running Narva Ultima 215s it is a smart buy backup part.

• Genuine Narva accessory bezel for Ultima 215 LED
• Suits Narva Ultima 215 High Powered Driving Light (71740)
• Gloss black finish to match modern bullbars
• Direct replacement ring for damaged or worn bezels
• Multiple mounting holes align with factory screw points
• Protects outer edge of lamp housing from chips and marks
• Maintains original light performance and beam pattern
• Ideal spare part for touring and off-road vehicles
• Sold as a single bezel ring
• Simple way to keep lighting setup looking uniform

Q: Is this sold as a single bezel or a pair?

This Narva Ultima 215 LED black bezel is supplied as a single unit. That makes it handy if you have only damaged one light ring on a dual setup. You can order one bezel to match the existing good light. If you want both lights to look brand new you can simply add two units to your cart.

Q: Does this bezel change the beam pattern of the Ultima 215 LED light?

No, this bezel is shaped to follow the existing Ultima 215 LED housing and does not alter the beam. It sits around the outside of the light body rather than across the lens. As long as it is mounted correctly the beam pattern and output remain as per the original lamp. The bezel is purely cosmetic and protective.

Q: Can I install this bezel with the light still on the vehicle?

In most setups you can swap the bezel with the driving light still bolted to the bar. The ring uses the small perimeter screws around the Ultima 215 body. You usually just remove those screws, lift off the old ring and refit the new one. Take care not to drop the hardware and avoid over-tightening when you reinstall.

Q: Is the gloss black finish suited to coastal use?

The gloss black bezel is suitable for normal use in coastal and inland areas. Regular washing with fresh water after beach runs will help keep the surface in good condition. Avoid harsh cleaners or cutting compounds that may mark the finish. With basic care the bezel will stay presentable on touring vehicles for years.

• Suits Narva Ultima 215 LED High Powered Driving Light (71740)
• Fits around the 215 mm driving light housing as a bezel trim
• Intended as a direct replacement for the original bezel on compatible lights