This Narva in-line mini blade fuse holder drops straight into a 12V line and keeps the fuse close to the gear you want to protect. The LED indicator shows when the mini blade fuse has blown so you are not chasing faults through a loom that runs several metres along the vehicle. The waterproof cap covers the slot and helps the setup cope with spray in wheel arches and ute trays. The housing uses hard plastic and a tight-fitting cap to keep dust and moisture off the contacts on long corrugated tracks. The integrated LED sits in the centre of the body so you can see it at a glance when current stops flowing above about 12 V. The red lead suits common accessory circuits that pull up to typical mini blade fuse ratings around 30 A. For the price, this is smart buy gear for anyone wiring lights, pumps or small 12V accessories.

• Narva in-line mini blade fuse holder for 12V circuits
• Supports standard automotive mini blade fuses
• Integrated LED indicator lights when fuse blows
• Waterproof cap protects fuse contacts from moisture
• Compact body suits tight engine bays and canopies
• Durable plastic housing for everyday automotive use
• Supplied as a single holder in blister pack
• Red lead makes circuit identification straightforward
• Ideal for lights, fridges and small accessories
• Simple add-on for clearer circuit protection in touring setups

Q: Does this fuse holder include a mini blade fuse?

No, this fuse holder is supplied without a mini blade fuse. You choose the correct amp rating fuse to match the circuit you are protecting. That lets you use the same holder across light, medium or heavier accessory loads. Always match the fuse rating to the cable size and the connected gear.

Q: Can the LED indicator work with standard 12V automotive systems?

Yes, the LED indicator is intended for typical 12V automotive circuits. When the mini blade fuse blows the LED receives a small current path and lights to show a fault. This helps in engine bays and canopies where access is tight. You can see which fuse holder needs attention without pulling every fuse.

Q: Is the waterproof cap suitable for under-bonnet use?

Yes, the holder has a flexible waterproof cap designed to cover the fuse slot in areas exposed to spray and dust. Under-bonnet locations near wheel arches or radiators often see water and grime. The cap helps keep contaminants away from the fuse blades. That reduces the chance of corrosion on long-term setups.

Q: What type of fuse fits this holder?

This holder is made for mini blade style fuses only. These are the smaller automotive blade fuses often used on accessory circuits. Using the correct physical size ensures firm contact on both blades. A standard or maxi blade fuse will not seat correctly. Always check the fuse size marking before installation.