Narva 35mm² 10mm Stud Flared Entry Cable Lugs sort out heavy cable terminations on gear that runs serious current. The barrel suits 35mm² cable so you can hook up battery links or anchor winch leads without stepping the cable down. The 10mm stud eye lands cleanly on common busbars and isolators. The pack of 10 lugs means you can wire a full setup without running short. These Narva lugs use a solid metal body sized for 35mm² conductors to keep resistance low under load. The flared entry on each lug guides the cable into the barrel and helps set up a straight crimp on 35mm² insulation. The tongue sits flat under standard 10mm hardware for a consistent contact patch. The pack of 10 keeps every termination matched across the install which is a smart buy for tidy wiring.

• Narva cable lug sized for 35mm² conductors
• Suits electrical hardware using 10mm studs
• Flared cable entry supports neat insertion
• Solid metal barrel for crimped terminations
• Pack includes 10 identical cable lugs
• Suitable for battery and high-current wiring
• Works in automotive, 4WD and marine setups
• Eye profile matches flat busbar connections
• Helps maintain low resistance in 12V systems
• Allows consistent terminations across full install

Q: Do these Narva lugs suit fine strand 35mm² battery cable?

Yes, these lugs are sized for 35mm² cable. Fine strand battery cable with a 35mm² cross‑section will fit inside the barrel before crimping. Using the correct size lug helps maintain current capacity and reduces heat. Always confirm the cable is marked 35mm² to match the lug.

Q: How many terminations can I make from one pack?

You can make up to ten individual terminations from one pack. Each pack contains ten identical 35mm² 10mm stud lugs. This suits dual battery systems, distribution blocks or multiple accessory feeds. Keeping all ten lugs the same size also makes future fault‑finding simpler.

Q: Are these lugs suitable for marine electrical boards?

These lugs can be used on marine electrical boards that accept 10mm studs and 35mm² cable. The 10mm eye suits many battery switches and busbars used on boats. The flared entry helps seat cable neatly in confined lockers. Always match the lug size to the cable and hardware already installed.

Q: What tools should I use to crimp these lugs?

Use a crimp tool rated for 35mm² cable lugs. A correct‑sized hex or indent crimper will compress the barrel onto the conductor. Matching the tool to the lug size helps avoid loose joints. A firm mechanical crimp also supports consistent performance across all ten lugs in the pack.