The Lightforce Replacement Mounting Base for Striker and Blitz Driving Light steps in when the original high mount is bent or missing, so you can keep those RM or RMDL lights on the bar and still punch solid light down the track. The compact bracket suits tight bull bar tabs and helps hold the light housing steady over corrugations and washouts without needing to rework your wiring or swap the whole setup. This little bit of gear comes from Lightforce, so it lines up with the hole spacing and stud size used on the matching Striker and Blitz housings and takes standard spanners and sockets in the shed. The base and hardware are built tough for long trips where dust, heat, and vibration usually shake lesser mounts apart. Bolt it on once, tension it properly, and get out there knowing the driving lights will stay put from the bush to the highway.

• Genuine Lightforce replacement high-mount base
• Suits Striker RM and Blitz RMDL lights
• Direct-fit bracket for existing housings
• Supplied with matching bolts, nuts and washers
• Compact mount suits common bull bar tabs
• Helps restore correct driving light alignment
• Ideal spare bracket for touring toolkits
• Simple bolt-on repair for damaged or lost bases
• Compatible with single-stud driving light setups
• Black bracket finish matches most light housings

Q: Is this mounting base sold individually or as a pair?

This mounting base is sold individually. If you want to refresh both driving lights on the vehicle, you will need to order two bases. Carrying a single spare in the kit is also handy on longer trips. Always check your current setup so you order the right number for your rig.

Q: Does this kit include all the mounting hardware shown?

Yes, the kit includes the bracket and matching nuts, bolts and washers shown in the images. Using the supplied hardware keeps the fit consistent with the original mount. Reusing old, stretched bolts can lead to movement over time. Always tighten the new hardware to a sensible tension without over-torquing.

Q: Can I fit this base to non-Lightforce driving lights?

This base is made to suit Lightforce Striker and Blitz style housings. Other brands may use different stud sizes or mounting widths. If the hole spacing or bolt size does not match, the light will not sit correctly. For non-Lightforce lights, look for a bracket specified for that exact model.

Q: Do I need to remove the driving light wiring to change the base?

In most setups the light can stay wired while you swap the base, as the mount sits below the housing. Supporting the light body with a box or rag helps while you undo the old hardware. Take care not to strain the cables while the mount is off. Once the new base is on, recheck alignment before tightening everything up.

• Suits Lightforce Striker RM driving lights
• Suits Lightforce RMDL Blitz driving lights
• High-mount configuration for existing housings
• Intended as a replacement mount base only