The Lenco Trim Tab Plate Only 9X12 Electro-Polished Single steps in when your original 9 x 12 plate cops a hit and bends. The plate runs a footprint of 228mm by 305mm so it lines up with standard Lenco gear on the transom. The standard series layout keeps the hinge and actuator geometry familiar so you can tackle headwinds and chop with the same trim range you are used to. This plate uses 12 gauge material with an electro-polished finish so it holds shape and shrugs off typical salt build-up. The pre-set bends and pre-drilled pattern suit standard 9 by 12 mounting so you are not chasing new holes across the transom. The finish is smooth across the 228mm length and 305mm width to keep water flow tidy. It is a smart buy if the rest of your Lenco setup is still in good nick.

• Single Lenco trim tab plate only
• Suits standard 9 x 12 Lenco setups
• Plate length 9 inch (228mm)
• Plate width 12 inch (305mm)
• Standard series pattern for matching hardware
• Electro-polished finish for cleaner appearance
• 12 gauge construction for structural stiffness
• 5 year warranty for recreational use
• Ideal when replacing a damaged 9x12 plate
• Compatible with existing Lenco actuators and brackets

Q: Is this trim tab plate supplied with actuators or mounting hardware?

No, this listing is for the trim tab plate only. It suits setups where your existing Lenco actuators, hinges, and brackets are still serviceable. Swapping just the plate keeps the geometry the same as your current 9 x 12 layout. Check your hardware for wear or corrosion before refitting so the new plate can work as intended.

Q: Can this 9 x 12 trim tab plate be used on either port or starboard sides?

Yes, a single 9 x 12 plate can be used on either side where your boat uses a matching Lenco standard series footprint. The key is to match the 228mm length and 305mm width to your original plate. Hole spacing and hinge line should remain consistent. Always confirm orientation before drilling any new holes in the transom.

Q: What type of use is covered by the 5 year warranty?

The 5 year warranty covers recreational use only. That means private boating where the vessel is not used for commercial hire or charter work. Using the plate within recreational limits helps keep stress within what the gear is made for. Always follow Lenco care guidelines to support long term performance.

Q: Do I need to modify my boat’s hull or transom to install this plate?

No hull modification is required when your boat already runs a Lenco 9 x 12 standard series trim tab. The plate shares the same size of 228mm by 305mm as the original component. Existing hinge holes and bracket locations should line up. Always dry-fit first and confirm sealant coverage before final tightening.