This Lenco Trim Tab Actuator Mounting Pin in Delrin suits Lenco 101 and 102 actuators so you can keep existing trim gear working without swapping the whole setup. The pin holds the actuator to the bracket so your tabs stay where you set them when the hull pushes through chop. The non-metal pin helps cut wear at that busy hinge where most of the steering trim loads sit.

The Delrin material is a hard acetal plastic that handles regular movement against metal hardware on coastal runs. The pin pairs with standard Lenco 101 and 102 trim tab actuators used on many trailer boats across Australia. The gear comes with a 5 year recreational use warranty so you know it is built to go season after season. Swap the worn pin and get out there with trim tabs working the way they should.

• Genuine Lenco trim tab actuator mounting pin
• Suits Lenco actuator models 101 and 102
• Manufactured from Delrin acetal plastic
• Non‑metal construction helps reduce galvanic contact
• Direct replacement for original actuator mounting pin
• Supports consistent trim tab movement under load
• Suitable for recreational marine applications
• Backed by 5 year recreational use warranty
• Compact spare part to keep onboard for maintenance
• Helps extend service life of existing trim tab hardware

Q: Is this mounting pin compatible with all Lenco trim tab systems?

No, it suits Lenco actuator models 101 and 102. This pin is sized and shaped for the specific mounting hardware used on those actuators. Using it on other actuator models may not give a secure fit. Always check the label or part number on your existing Lenco actuator. If it is marked 101 or 102 this pin is made to match.

Q: What type of boats is this pin intended for?

It is intended for recreational marine use. The 5 year warranty applies to recreational applications such as trailer boats and pleasure craft. Commercial or high‑duty vessels typically have different service requirements. If your boat runs long daily hours or commercial trips talk with your service technician. They can confirm if this recreational‑rated part suits your setup.

Q: Do I need to replace both actuator mounting pins at the same time?

It is recommended to replace pins as a pair. When one pin shows wear the other is usually close behind. Replacing both keeps the actuator mount points balanced on each trim tab. That helps the tabs move evenly when you use the helm controls. Matching wear levels also makes future checks and servicing simpler.

Q: How should I look after this Delrin mounting pin?

Rinse the area with fresh water after saltwater use. Regular freshwater rinses help clear salt and grit from the actuator mount. This reduces abrasion between the Delrin and metal hardware. A quick visual check during routine maintenance will show any unusual wear marks. If the pin looks scored or loose it is time to change it out.

• Suitability: Lenco trim tab actuator models 101 and 102
• Application: replacement mounting pin for trim tab actuator assemblies in marine setups
• Use case: recreational marine vessels using Lenco 101 or 102 trim tab systems
• Installation: fits in place of original actuator mounting pin for compatible Lenco actuators