The Lenco Hatch Lift Switch Single Actuator runs the up and down control on a single ram hatch lift rated at 20 amp. You get a clear rocker marked UP and DOWN so hatch position is obvious when you are watching the water. Two non-terminated power leads at 760mm give enough reach to tie into the existing loom at the dash or engine bay and keep joins away from spray.

This switch is CE certified and ABYC compliant so it lines up with common marine wiring standards on Aussie boats. The 20 amp capacity suits most Lenco single actuator hatch systems on 12V setups without stressing the contacts. The clam shell packaging keeps the rocker and terminals clean on the shelf until you are ready to fit it. If you are tidying up old hatch controls this is a smart buy that keeps the gear simple.

• Rocker switch for Lenco hatch lifts
• Suits single actuator hatch lift systems
• Rated to handle up to 20 amp
• Includes two non-terminated power leads
• Power lead length is 760mm each
• CE certified marine electrical component
• ABYC compliant for boat installations
• Clam shell packaged for protection in transit
• Clearly marked UP and DOWN rocker face
• Ideal replacement control for existing hatch lifts

Q: Is this switch suitable for dual actuator hatch lift systems?

No, this switch is described for single actuator hatch lift setups. Dual actuator systems often use different switching arrangements to keep both actuators synchronised. Using gear that is not matched to the system can overload the switch or leave one ram out of phase. For twin actuators, check the hatch lift documentation and choose the correct matched control.

Q: Are the two 760mm power leads pre-terminated with connectors?

No, the description states the power leads are non-terminated. That means the copper ends are left bare so the installer can crimp or solder to match the boat wiring. This lets you choose ring terminals, blade connectors or joiners that suit your existing loom. It also helps keep joins neat and protected in tight helm cavities.

Q: What electrical rating does this Lenco hatch lift switch carry?

The switch is rated at 20 amp. That rating indicates the continuous current the contacts are designed to handle in normal marine hatch lift use. Matching the actuator draw to this figure reduces heat buildup in the rocker body. Staying within the rating helps the switch last longer in regular up and down cycles.

Q: Does this hatch lift switch meet recognised marine standards?

Yes, the description lists CE certification and ABYC compliance. CE certification means the switch meets specific safety and performance criteria for electrical gear. ABYC compliance aligns it with common marine installation guidelines used by many boat builders. These standards help ensure the equipment suits typical Australian marine electrical practices.

Hatch lift switch suits Lenco single actuator hatch lift systems on marine vessels where a single actuator controls the hatch movement. Wiring connects via two non-terminated power leads of 760mm length which must be terminated to suit the existing boat wiring layout by the installer or marine electrician.