This Lenco Delrin Mounting Pin kit steps straight into 101 and 102 trim tab actuators that run a 38mm (1.5") pin. The gear replaces worn pivots so your tabs still move cleanly through their full stroke in chop and swell. Each pack carries two matching pins so you can sort both ends of a 38mm mounting point in one go and get back on the water. The pin uses Delrin acetal plastic which handles constant movement against stainless hardware and common saltwater temperatures around 0°C to 50°C. The 38mm diameter matches standard Lenco 101 and 102 specs so fit and alignment stay tight. This is small but important hardware for boats that lean on electric tabs to trim hull attitude and keep engines in their sweet spot on long runs along the coast.

• Genuine Lenco Delrin mounting pin

• Suits Lenco 101 trim tab actuators

• Suits Lenco 102 trim tab actuators

• 38mm (1.5") pin diameter

• Pack of 2 replacement pins included

• Delrin acetal construction for low friction

• Helps maintain smooth trim tab movement

• Simple replacement for worn pivot pins

• Suitable for marine trim tab installations

• Compact spare part for onboard tool kits

Q: How many mounting pins are in each pack?

Each pack includes two mounting pins. That means you can replace both sides of a single 38mm mounting point or keep a spare on hand. Carrying a second pin is handy if you run twin tabs and want consistent wear across both actuators. Swapping both pins together keeps the trim geometry even.

Q: Which Lenco actuators does this pin suit?

This pin suits Lenco 101 and 102 actuators that use a 38mm (1.5") mounting pin. Always check the actuator model number on the body or your existing paperwork before ordering. Matching the 38mm size is important so the pin seats correctly. A correct fit helps prevent slop at the trim tab pivot.

Q: What is the pin made from?

The pin is made from Delrin acetal plastic. This material is widely used for bushings and wear components that sit against metal hardware. Delrin offers low friction at the pivot point which helps the actuator move smoothly. It also resists swelling and absorbs little water in marine use.

Q: Is this pin suitable as a spare part for onboard repairs?

Yes it suits use as a spare trim tab mounting pin. Keeping a pack of two pins onboard means you can swap out a worn or damaged 38mm pin during a trip. The compact size makes it simple to store in a small spares kit. Having the right pin helps keep your trim system operational if a pivot fails.

• Suits Lenco 101 actuators with 38mm (1.5") mounting pin size

• Suits Lenco 102 actuators with 38mm (1.5") mounting pin size

• Intended for marine trim tab actuator installations

• Check actuator model number 101 or 102 prior to ordering