The Coast to Coast LED Grab Handle Black gives you a lit handhold at the door of the van with a blue LED tube running on 12V DC. The clear centre section throws light along the length of the handle so you can see the first step when you pull up at camp after dark. A red push button on the housing flicks the LEDs on or off without reaching for a separate switch.

The handle uses a solid plastic tube between black plastic end mounts fixed with two screws and matching gaskets for a neat fit against a flat wall. The LED strip sits protected inside the tube and works off the same 12V system as your interior lights. The compact footprint suits most caravan and RV door frames, making it a smart buy for anyone wanting lit entry gear that runs off existing touring electrics.

• Coast to Coast LED grab handle for caravan and RV entry
• Integrated blue LED lighting inside clear centre tube
• Operates from standard 12V DC electrical systems
• Red push button switch built into handle housing
• Black end caps with clear tubular grip section
• Supplied with two mounting screws for installation
• Includes two gaskets to sit between handle and wall
• Surface-mount design suits flat caravan or RV panels
• Provides a solid handhold at the doorway in low light
• Compact grab handle style suited to most door surrounds

Q: Does the LED grab handle work on 24V systems?

No, this LED grab handle is for 12V DC systems only. Caravan and RV house batteries are typically 12V, which suits the handle electronics. Running it on 24V could damage the LEDs or switch. For trucks or buses with 24V systems, a suitable reducer or different handle would be required.

Q: Can the light be used without the handle being mounted vertically?

Yes, the handle can be mounted in any orientation on a flat surface. The LED strip sits inside the clear tube, so it will still light along its length horizontally or at an angle. Just make sure the mounting surface is strong enough to take body weight. Always fasten both ends with the supplied screws and gaskets.

Q: Is the switch built into the handle or separate?

The switch is built into the handle housing as a red push button. This means you do not need to wire in a separate wall switch to control the light. You simply connect the handle to a fused 12V feed and use the button to turn the blue LEDs on or off. This keeps the wiring run short and tidy.

Q: What kind of surface can I mount this handle to?

The handle is intended for solid caravan and RV wall sections around the doorway. It mounts with two screws through the end caps, compressing the gaskets against a flat panel. Thin or hollow linings should be backed with suitable structure. Using the correct screws for your wall construction helps the handle stay secure when people use it as a grab point.

• Intended for caravan and RV entry areas
• Requires 12V DC electrical supply for LED function
• Handle mounts via two screws through supplied gaskets
• Suitable for flat mounting surfaces where a grab handle is required