KT Accessories Split Loom Tubing in 29 mm x 30 m gives you a straightforward way to tidy and protect wiring runs on trailers and touring rigs. The split design means you can drop it over existing looms that already carry several millimetres of insulation and tape. The 30 m roll covers multiple jobs so you can tackle canopy fitouts and tow‑vehicle repairs from the same spool. This gear uses convoluted black plastic with a nominal 29 mm internal diameter so it suits chunky harness bundles on dual batteries and accessory circuits. The 30 m continuous length lets you cut sections from under 1 m right up to full‑length chassis runs without extra joins. The split wall makes cable access simple when you need to trace or replace a wire. It is solid gear for workshops and home garages across Australian conditions.

• KT Accessories split loom tubing

• Black convoluted tube for cable protection

• Internal diameter approximately 29 mm

• Supplied in a 30 m continuous roll

• Split design for fitting over existing wiring

• Suitable for automotive and trailer harnesses

• Convoluted profile improves abrasion resistance

• Roll format suits workshop and trade use

• Helps keep wiring runs neat and organised

• Simple to cut to required length

Q: Can I cut this split loom into shorter lengths?

Yes you can cut the 30 m roll to any length you need. Most people use side cutters or a sharp utility knife. Shorter sections suit engine bay links between fuse blocks and relays. Longer lengths work well along chassis rails or tray bodies. Just make sure the cut edges are clean so they do not catch on cable insulation.

Q: What cable bundle size will this loom fit?

This loom suits cable bundles up to about 29 mm outside diameter. Measure your existing harness across the widest point before ordering. If the bundle is close to the stated size allow a little room for movement. Oversized bundles may not close neatly along the split.

Q: Is this tubing suitable for general automotive 12 volt work?

Yes the loom is suitable for typical 12 volt automotive and trailer wiring. The convoluted wall helps protect insulation from rubbing on metal brackets and panels. The black colour matches common automotive cable jackets. The 30 m length gives enough coverage for full vehicle rewires.

Q: Does the tubing come on a spool?

Yes this 29 mm split loom is supplied on a spool. The spool keeps the 30 m length tidy in the workshop. It helps prevent kinks while you unroll sections for each job. It also makes storage on shelves or in service vehicles straightforward.