This Koyorad radiator steps straight into Subaru Forester 2.5L autos run between July 2005 and February 2008 so you can get out there without chasing odd fitment parts. The core stands at 360 millimetres high and 686 millimetres wide which lines up with factory shrouds and fans. The 16 millimetre core thickness keeps coolant moving while still clearing belts and pulleys in the tight engine bay. The unit runs 39 millimetre inlet and outlet necks so standard Forester hoses slide on without drama. The built in transmission cooler keeps auto fluid inside the same 360 by 686 millimetre package which means fewer joins and less chance of leaks. The radiator suits Aussie heat where long highway pulls and slow bush tracks can push temps up. This is straight up cooling gear for drivers who want a smart buy that just works.

• Suits Subaru Forester 2.5L automatic models built 07/2005–02/2008
• Koyorad UZH-34002 radiator with direct-fit dimensions
• Core height of 360 mm for strong frontal coverage
• Core width of 686 mm matched to Forester front support
• Core thickness of 16 mm for balanced flow and clearance
• 39 mm inlet neck sized for factory upper hose
• 39 mm outlet neck matched to factory lower hose
• Integrated transmission cooler for automatic gearbox lines
• Rectangular 360 x 686 mm core suits standard fan shroud
• Ideal replacement unit for tired or leaking factory radiator

Q: Will this radiator fit a manual transmission Subaru Forester 2.5L of the same years?

This radiator is specified for automatic transmission models only. The integrated transmission cooler and port layout are matched to auto gearbox lines. Manual cars usually run different tank configurations. Always confirm part number against your VIN before ordering to avoid mismatched fittings.

Q: Do I need to modify the original radiator hoses to use this unit?

No, the inlet and outlet necks are specified at 39 mm to suit factory hoses. Check your old radiator neck diameter to confirm it matches 39 mm. If your existing hoses are worn or swollen it is a good time to replace them. Fresh clamps and hoses help the cooling system hold pressure properly.

Q: Is this radiator suitable for towing and highway driving in hotter regions of Australia?

Yes, the 360 mm by 686 mm core is sized to manage heat under sustained load. The 16 mm thickness balances coolant flow with fin area for long climbs and summer traffic. Correct coolant mix and a functioning thermostat remain important. Keep the outside of the core clear of mud and seeds for best performance.

Q: Does the radiator come filled with coolant or transmission fluid?

No, the radiator is supplied dry without fluids. You will need to add the correct coolant mix specified in the Subaru handbook. Automatic models also require a transmission fluid level check after bleeding air from the cooler circuit. Always dispose of old coolant and fluid through approved collection points.

Suitable for Subaru Forester with 2.5L engine built from July 2005 to February 2008 with automatic transmission. Installation requires removal of the existing radiator and transfer of original hoses and mounts where compatible. Fitment should follow Subaru factory workshop procedures and specified coolant type and capacity. Check inlet and outlet diameters of 39 mm against existing hose sizes before installation.