Hard Korr XDD Gen3 End Mount Legs Pair gives you a solid way to hang an XD Gen3 LED bar off a bullbar hoop or rack crossbar without chequer plate brackets everywhere. Two legs clamp each end of the housing so the bar stays put when you tackle corrugations or station tracks. Rubber bases sit between the feet and steelwork to calm down vibration and help the beam stay pointed where you set it. Each leg is purpose made for the XD Gen3 series so bolt spacing and angle line up with the bar body straight out of the box. Hardware pack includes security bolts nuts and an Allen key so you are not chasing odd fasteners at the servo. The compact footprint suits narrow roof rack rails and crowded front bars which makes this kit a smart buy when space is tight but you still want reliable light bar mounting.

• Pair of end-mount legs for XD Gen3 LED light bars
• Suits compact end mounting on bullbars or roof racks
• Includes two rubber bases for each mounting foot
• Supplied with two security bolts for each light bar end
• Includes matching nuts and bolts for secure fastening
• Allen key included to suit the supplied security bolts
• Strong construction suitable for external 4x4 lighting setups
• Rubber bases help reduce vibration between bar and mounting surface
• Purpose-made geometry matches Hard Korr XD Gen3 light bar housings
• Complete hardware kit reduces need for extra mounting parts

Q: Are these mounts only for Hard Korr XD Gen3 light bars?

Yes, these end-mount legs are made for Hard Korr XD Gen3 series light bars. The bolt pattern and mounting face match the XD Gen3 housings. Using them on other bars may not line up correctly. For other brands or series, check their specific mounting hardware.

Q: What tools do I need apart from the supplied Allen key?

You will need a spanner or socket to suit the supplied nuts. The Allen key in the kit fits the security bolt heads. Holding the nut with a spanner while turning the Allen key lets you tighten the mounts. Always recheck tension after the first drive.

Q: Can I mount the legs on roof racks as well as bullbars?

Yes, the legs can mount to any suitable flat or bracketed surface that accepts the supplied studs. Many users fit them to steel or alloy roof rack crossbars. Make sure the rack has enough strength for the light bar weight. Always mount to structural points rather than thin sheet.

Q: Do the rubber bases help with water sealing?

The rubber bases mainly spread load and reduce vibration between the leg and mounting surface. They can also limit water sitting directly between metal surfaces. They are not a substitute for proper sealing where holes pass through panels. Use suitable sealant if you drill through bodywork or enclosed cavities.

These end-mount legs are intended for use with Hard Korr XD Gen3 series LED light bars. They provide end-style mounting points suitable for bar-style installations on compatible brackets or surfaces. Installation uses the supplied security bolts, nuts and Allen key to attach the legs to the light bar and mounting surface. Always check the mounting surface and existing brackets for strength and suitability before fitting the light bar and legs.