This Jayrad radiator slots into Toyota Prado RZJ and VZJ manual models from 1996 to 2003 with a core size of 425 by 720 millimetres so you can keep coolant temps in check when you get out there loaded with camping gear. This 48 millimetre thick two row core carries enough coolant volume to tackle long climbs without the gauge creeping up. This unit runs standard 38 and 42 millimetre hose connections for straightforward hookup. This JR2068J core spreads across 720 millimetres of frontal area so airflow from the Prado grille actually goes to work on the fins. This 425 millimetre height lines up with factory shrouds so the fan pulls air across the whole surface not just the middle. This built tough design includes an integrated transmission cooler section to support the driveline during towing or beach work. This radiator is a smart buy for older Prados that still tour hard.

• Suits Toyota Prado RZJ and VZJ manual models 1996–2003
• Core height of 425 mm for correct frontal coverage
• Core width of 720 mm to match factory mounting points
• Core thickness of 48 mm using a two row layout
• 38 mm inlet diameter for standard upper hose
• 42 mm outlet diameter for standard lower hose
• Integrated transmission cooler section within the tank
• Direct replacement style radiator from Jayrad
• Suitable for touring and towing when cooling system is maintained
• Designed as part of 4x4 and touring performance cooling gear

Q: Will this radiator fit my 2000 Toyota Prado manual?

Yes, this radiator suits Toyota Prado RZJ and VZJ manual models built between 1996 and 2003. Always confirm your vehicle’s build year and engine code before ordering. Matching the 425 mm height and 720 mm width to your existing radiator is a good cross check. If those dimensions line up, you are looking at the right gear for your Prado.

Q: Does this radiator include a built-in transmission cooler?

Yes, this radiator includes an integrated transmission cooler section. The cooler sits inside the tank so transmission fluid passes through its own sealed circuit. This design means coolant and transmission fluid stay separate. You still need to reconnect the transmission lines during installation and check fluid levels afterwards.

Q: Do I need new hoses to use this radiator?

Not usually, because the inlet diameter is 38 mm and the outlet diameter is 42 mm. These measurements match standard hose sizing on compatible Prado models. If your existing hoses are cracked or swollen, replacing them at the same time is a smart move. New clamps and fresh coolant also help the cooling system last longer.

Q: Is this radiator suitable for towing and long-distance touring?

Yes, the two row 48 mm thick core gives more coolant volume than a single row unit. That extra capacity helps manage temperatures during towing or long highway runs. The integrated transmission cooler also supports the driveline when you are hauling a camper or boat. Just make sure your fan, shroud and coolant are all in good condition for best results.

Suitable for Toyota Prado RZJ and VZJ manual models built between 1996 and 2003. Verify core height of 425 mm and width of 720 mm against the original radiator before install. Check inlet diameter of 38 mm and outlet diameter of 42 mm match existing hose sizes. Professional installation is recommended for correct coolant bleeding and connection of the integrated transmission cooler.