This Jayrad JR2847J radiator drops into Toyota Land Cruiser HZJ 70 Series manual rigs from 1999 to 2006 so you can get out there without heat soak stopping the trip. The core stands at 500 mm high with a 518 mm width to match the factory fan sweep when you tackle slow climbs or sand work. A 48 mm thick 2-row core moves plenty of coolant for towing or loaded touring. This kit keeps the hose layout straightforward with 38 mm inlet and 38 mm outlet necks that line up with standard Land Cruiser coolant hoses. The 48 mm core thickness gives more tube and fin area to dump heat when ambient temps push over 35 degrees out bush. The 500 mm by 518 mm footprint suits the standard radiator support so the rest of your engine bay setup stays familiar. Solid specs like these make it a smart buy for long term use.

• Jayrad JR2847J radiator for Land Cruiser
• Suits Toyota Land Cruiser HZJ 70 Series
• Compatible with 1999–2006 manual models
• Core height measures 500 mm
• Core width measures 518 mm
• Core thickness is 48 mm two row
• Inlet pipe diameter is 38 mm
• Outlet pipe diameter is 38 mm
• Direct style replacement cooling gear
• Suitable for 4x4 touring and towing use

Q: Does this radiator fit automatic transmission Land Cruisers?

No, this radiator suits manual transmission models only. The listing specifies M/T which indicates manual transmission compatibility. Automatic models often need a built in transmission cooler or different tank configuration. Always check your vehicle plate and transmission type before ordering. If you run an auto, match part numbers against an auto-specific unit.

Q: Do I need to modify my hoses to fit this radiator?

You should not need to modify hoses if your vehicle matches the listed models. The inlet and outlet are both 38 mm, which matches standard HZJ 70 Series hose sizes. Check that your existing hoses are still in good condition before reusing. Cracked or swollen hoses are best replaced during the radiator swap. Correct hose size helps keep clamps sealing properly.

Q: What core size should I check before ordering?

You should confirm the height and width of your existing radiator core. This unit runs a 500 mm high core and 518 mm wide core, so your old radiator should measure close to these numbers. Measuring the finned area only gives the best comparison. A quick check with a tape measure can prevent ordering the wrong unit for your Cruiser.

Q: Is this radiator suitable for heavy towing work?

This radiator is built with a 48 mm thick 2-row core which supports higher cooling capacity than many single row designs. For heavy towing, correct fan operation and shroud fit also matter. Make sure the fan clutch, shroud and coolant mix are in good order. A clean grille and bug-free fins also help the 500 mm by 518 mm core work at its best.

Suits Toyota Land Cruiser HZJ 70 Series manual transmission models built between 1999 and 2006. Fitment requires compatibility with a core height of 500 mm and core width of 518 mm. Cooling hoses must match the 38 mm inlet and 38 mm outlet diameters. Installation should follow standard radiator replacement procedures for the HZJ 70 Series engine bay layout.