This Jayrad JR2208J radiator keeps the old LandCruiser workhorses in the game, covering HJ60 and HJ61 with 4.0 L diesel from 1981–1990. A core size of 500 mm high by 530 mm wide gives the fan plenty of area to pull air through when you are crawling up a low-range climb. The 64 mm thick core with 4 rows of tubes helps the cooling system cope with slow going in soft sand or traffic.

The 40 mm inlet and 40 mm outlet match standard hoses, so flow stays right for that long-stroke diesel. Factory-style dimensions of 500 x 530 x 64 mm line up with original shrouds and mounts, which makes this a smart buy when freshening an older touring rig. An included transmission cooler section suits manual driveline setups that spend hours pulling weight across hot bitumen.

• Suits Toyota Land Cruiser HJ60 and HJ61 4.0L diesel engines
• Compatible with manual transmission models from 1981–1990
• Core height of 500 mm for strong frontal coverage
• Core width of 530 mm to match factory mounts
• 64 mm thick four row core for improved heat transfer
• 40 mm inlet diameter to suit standard upper hose
• 40 mm outlet diameter for direct-fit lower hose
• Includes transmission cooler provision for manual layouts
• Direct replacement dimensions for factory-style radiator support
• Suitable for touring, towing and heavy-load driving in hot conditions

Q: Does this radiator suit both wagon and cab-chassis HJ60 models?

Yes, it suits both body styles provided they run the 4.0L diesel with manual transmission. The important match is the engine and cooling layout, not the body behind it. As long as the vehicle uses the original-style radiator support and shroud, the 500 mm by 530 mm by 64 mm core size will line up. Always compare measurements against the unit you are replacing.

Q: Can I use my existing radiator hoses with this unit?

Yes, if your current hoses suit a 40 mm neck size. This radiator has a 40 mm inlet and 40 mm outlet, which matches the standard hose sizing on these Land Cruisers. If your old hoses are swollen or cracked, it is worth replacing them at the same time. Fresh clamps and coolant usually round out the job well.

Q: Is the transmission cooler section compatible with automatic gearboxes?

No, this unit is specified for manual transmission setups. The catalogue listing ties this part number to manual HJ60 and HJ61 models, and automatic layouts may use different cooler routing. Using the wrong style can cause line routing or pressure issues. Check your VIN and gearbox type before ordering.

Q: What coolant capacity change should I expect when fitting this radiator?

The overall coolant volume stays close to the original unit because the core dimensions are matched. The 64 mm four row design focuses on surface area rather than a big jump in capacity. Always refill using the coolant volume recommended in the workshop manual. Then bleed the system carefully and recheck the level after a short drive.

• Suits Toyota Land Cruiser HJ60 and HJ61 with 4.0L diesel engine
• Suits manual transmission vehicles from 1981–1990
• Suits models with cab chassis or wagon configuration
• Fits cooling system layouts that match 500 mm x 530 mm x 64 mm 4 row core size
• Requires reuse of original hoses sized for 40 mm inlet and 40 mm outlet
• Professional installation recommended for correct coolant fill and bleeding