This Jayrad fan clutch JFC006 bolts up to Mitsubishi Triton ML 4G64 and 4G63 engines plus Express Starwagon 2.0 L and 2.4 L petrol setups. You get a flange screw type hub with an 18 mm pilot that lines up with the factory water pump. The overall height comes in at 68.5 mm so the fan sits where Mitsubishi intended and the belts track straight when you tackle slow climbs and tight tracks. The housing runs a 168 mm outside diameter with a 153 mm fan bolt circle so your standard 4WD fan bolts straight on. The finned metal body is built tough for long hours in traffic and on the highway when temps push past 40°C. Every spec matches common OEM dimensions so you can treat it as smart buy replacement gear and get out there without chasing custom brackets or spacers.

• Jayrad engine cooling fan clutch assembly
• Suits Mitsubishi Triton ML 4G64 petrol engines
• Also suits Mitsubishi Triton ML 4G63 petrol engines
• Compatible with Mitsubishi Express Starwagon 2.0 L engines
• Compatible with Mitsubishi Express Starwagon 2.4 L engines
• Flange screw type mounting for factory-style fit
• Overall clutch height of 68.5 mm
• 18 mm pilot hole for hub location
• Fan blade bolt circle diameter of 153 mm
• Outside body diameter of 168 mm for shroud clearance

Q: Does this Jayrad fan clutch include the engine fan blades?

No, this Jayrad fan clutch does not include fan blades. It is supplied as the clutch hub assembly only, which bolts to your existing fan on the 153 mm bolt circle. Reusing the original fan keeps the setup matched to the shroud. Always check the fan blade for cracks or fatigue before reinstalling.

Q: How can I confirm this clutch will fit my Mitsubishi before ordering?

Confirm both the engine code and the key dimensions. Your vehicle must run a 4G64 or 4G63 Triton ML engine, or a 2.0 L or 2.4 L Express Starwagon engine. Then measure the fan bolt circle at 153 mm and the pilot at 18 mm. Matching these figures gives a reliable guide to correct fitment.

Q: What measurements should I check on my old fan clutch when replacing it?

Measure the overall height, the pilot hole, the fan bolt circle and the outside diameter. This Jayrad unit has a 68.5 mm height, 18 mm pilot, 153 mm fan bolt circle and 168 mm body diameter. If your old clutch matches these numbers, this replacement will sit correctly in the shroud and line up with the belts.

Q: Is this fan clutch suitable for heavy stop–start city driving in hot weather?

Yes, this style of viscous fan clutch is commonly used for heavy stop–start use in hot climates. The 168 mm finned body helps move heat away from the working fluid so it can keep engaging the fan at low road speeds. When paired with a sound radiator and fan shroud it provides steady airflow across the core in typical Australian summer traffic.

• Suits Mitsubishi Triton ML fitted with 4G64 petrol engine
• Suits Mitsubishi Triton ML fitted with 4G63 petrol engine
• Suits Mitsubishi Express Starwagon with 2.0 L petrol engine
• Suits Mitsubishi Express Starwagon with 2.4 L petrol engine
• Flange screw type mounting with 18 mm pilot hole
• Fan blade bolt circle of 153 mm for matching fan
• Outside diameter 168 mm for correct shroud clearance
• Confirm measurements against existing fan clutch before installation