The iCheck TPMS Wheel Sensor Number 10 slots straight into an existing iCheck TPMS setup when you need a fresh sensor for that tenth wheel spot, so you can still keep an eye on pressures across bigger towing or caravan rigs with more than four tyres in play. The clear number 10 on top makes it simple to line up with your display when you are swapping rubber around. Inside the small housing you have the same electronic layout used across the wider iCheck TPMS range, so it talks properly to the matching in-cab screen without fiddling around. The tough plastic shell shrugs off the dust and road grime you hit on long runs between 80 km/h and highway pace, while the low weight keeps the load on the valve stem sensible. If a single sensor cops a hit, grabbing this numbered replacement is a smart buy.

• Genuine iCheckTPMS replacement wheel sensor
• Marked as Sensor Number 10 on cap
• Suits compatible iCheck TPMS monitoring systems
• Ideal for replacing a damaged or lost sensor
• Helps maintain tyre pressure visibility on large setups
• Compact cap-style housing fits standard valve stems
• Light sensor mass reduces strain on valve hardware
• Numbered design keeps wheel position mapping simple
• Single sensor supplied for targeted replacement
• Matches the broader iCheck TPMS replacement sensor range

Q: Can I use this iCheck TPMS Sensor Number 10 on any brand of TPMS kit?

No, this sensor is intended for compatible iCheck TPMS systems only. The electronics and coding are matched to iCheck receivers, so other brands generally will not recognise it. For best results, pair it only with an existing iCheck TPMS monitor. Mixing brands can lead to dropped signals or no readings at all.

Q: Is this supplied as a full kit or just a single wheel sensor?

This listing is for a single wheel sensor only. It is meant as a replacement when one numbered sensor in your current setup is damaged or lost. You will still need your original iCheck TPMS display unit. If you are starting from scratch, look for a complete iCheck TPMS kit instead.

Q: Do I need any special tools to fit this sensor onto the valve stem?

No, the sensor threads onto a standard tyre valve stem by hand. Just remove the existing valve cap and screw the sensor on until it is firm. Avoid using pliers so you do not damage the housing. Always check for air leaks with soapy water after fitting.

Q: How do I know this is the right numbered sensor for my setup?

Check the sensor number assigned to the wheel position on your TPMS display first. If your screen shows position 10 as faulty or missing, this Number 10 sensor is the correct replacement. Matching the printed number on the cap with the slot on your display keeps each wheel’s readings in the right place.

Other iCheck TPMS replacement wheel sensors are available in different sensor numbers under the iCheck TPMS Replacement Wheels Sensors range.

This wheel sensor number 10 suits iCheck TPMS systems that support individually numbered external wheel sensors. The sensor is allocated to wheel position 10 within the compatible iCheck TPMS kit. Installation requires an existing iCheck TPMS head unit and remaining system hardware. Follow the original iCheck TPMS pairing and installation instructions supplied with your monitoring kit.