The iCheck TPMS Replacement Wheel Sensor Number 7 steps in when one channel in your existing kit cops a hiding. The numbered cap keeps that wheel position sorted so you do not mix up corners on a six or eight wheel setup. The compact sensor adds only a few extra millimetres to valve length so it stays out of the way of rocks and ruts when you get out there on rough roads. A tough plastic housing and sealed body keep dust and road grime away from the internals over long stints in heat above 30°C or cooler nights down near single digits. The sensor threads straight onto a standard valve stem that runs around 8 mm diameter. Low internal power draw means the battery runs for many months before swap out. It is a smart buy if the rest of your iCheck kit is still working fine.

• Genuine iCheckTPMS replacement wheel sensor
• Supplied as dedicated Sensor Number 7
• Suits existing iCheck TPMS monitoring kits
• Valve cap style sensor for simple install
• Compact low-profile housing for off-road use
• Printed number on cap for quick identification
• Helps restore full tyre pressure coverage
• Ideal when only one original sensor is lost
• Hard plastic outer shell for physical protection
• Single-sensor purchase avoids replacing whole kit

Q: Is this iCheck TPMS sensor sold individually or as part of a kit?

This iCheck TPMS Replacement Wheel Sensor Number 7 is sold as a single sensor only. It is made to slot into an existing iCheck TPMS kit when one wheel sensor is lost or damaged. That means you do not receive a display unit or extra sensors with this part. It is best suited to drivers who already run an iCheck TPMS system on their vehicle.

Q: Can I use sensor number 7 in place of another iCheck sensor number?

You should match the sensor number to the channel number on your existing kit. Each iCheck TPMS sensor is coded to a numbered position so the display can show the right wheel. Swapping numbers around can make it harder to know which tyre needs attention. For clean setups most owners keep the printed sensor number matched to the same display channel.

Q: Does this replacement sensor fit standard 4x4 tyre valve stems?

This sensor is built for standard valve stems used on passenger and light 4x4 wheels. The body screws on like a normal valve cap using the usual external valve thread. If your existing iCheck TPMS sensors fit your wheels then this replacement number 7 will suit the same stems. Custom race valves or unusual stems may not match the thread.

Q: Do I need to reprogram my iCheck TPMS screen after installing this sensor?

In most cases you will pair the new sensor number 7 to the matching channel on your screen. The pairing process ensures the monitor reads pressure from the correct wheel. The steps will follow the instructions supplied with your original iCheck TPMS kit. Once paired the system should treat this replacement the same as the original sensor.

Other numbered iCheck TPMS replacement wheel sensors may be available separately, including sensor numbers 1 to 6 and 8, under the same parent range.