This Hulk 4x4 Dual USB Socket QC3 replaces the square Toyota switch blank in late model dashes and adds two charge points right where you need them. The kit suits a square Toyota aperture from around 2019 onwards and keeps everything looking factory. The blue LED on the face lets you see at a glance that the circuit is live when you head off before sunrise. This gear runs two QC3.0 USB ports rated at 5 V output through a compact body about 50 mm deep. The black plastic housing matches common Toyota trim so the dash still looks tidy. The square face sits roughly 20 mm by 20 mm and clips into the standard opening. The rear takes typical 6.3 mm spade terminals so any auto sparky or switched-on DIYer can hook it into an existing 12 V accessory feed.

• Dual USB QC3.0 charge ports
• OE-style square face for Toyota dash
• Suits Toyota models from approximately 2019 onwards
• Blue LED status light on front panel
• Compact body to suit shallow switch recesses
• Black plastic housing to blend with dash trim
• Rear connections accept standard spade terminals
• Dash-mount location keeps charging leads short
• Replaces a factory switch or blank opening
• Suitable for typical 12V accessory circuits

Q: Does this socket replace an existing Toyota dash switch?

Yes, it is shaped to replace a square Toyota dash switch opening used on later models. The face is sized to match the factory blank so it clips in neatly. This keeps the dash looking tidy instead of using surface mount sockets. It also puts the USB points up high and away from foot wells. Always confirm your opening is square and similar in size before purchase.

Q: Can both USB ports be used at the same time?

Yes, both ports are available for charging together within the output limits of the socket and vehicle circuit. Running two devices will share the available current across both outputs. Make sure the feed wire and fuse size match the load you plan to run. Avoid stacking extra adaptors on the same circuit if it is already close to its fuse rating.

Q: Is this socket suitable for 12V systems only?

This style of in-dash USB charger is intended for typical light vehicle 12V accessory circuits. Most 4x4s and utes in Australia run 12V systems for cabin accessories. Higher voltage truck systems normally use different gear and wiring standards. Check your vehicle specifications and consult an auto electrician if you are unsure.

Q: Do I need professional installation?

Professional installation is recommended if you are not confident with automotive wiring and fusing. An auto electrician can confirm correct wire size and fuse protection. Correct installation reduces the chance of voltage drop or hot joints behind the dash. A neat job also makes future fault finding and upgrades much simpler.

Toyota 2019 onwards square shape.