The LV Automotive Handle To Suit 175-350Amp Anderson Connectors gives your Anderson style plug a proper handhold so you are not yanking on cables carrying 12V loads around 175 Amp or up to roughly 350 Amp. The triangular grip sits off the back of the connector by about 40 mm so you can grab it with gloves on when you are hooked up near the towbar or in a canopy corner. The kit works well on winch feeds and fridge leads.

The handle uses a tough plastic frame and a pair of steel screws that match the mounting points on common 175 Amp and 350 Amp Anderson housings. The bracket length keeps total connector size around 120 mm so it still fits most drawers and battery boxes. The grey finish blends in with standard electrical gear and is simple to spot against darker carpet or tub liners. It is smart buy gear for anyone running high current plugs.

• Handle to suit 175 Amp Anderson connectors
• Also suits 350 Amp Anderson connectors
• Triangular grip for positive handhold
• Helps avoid pulling on electrical cables
• Supplied with mounting screws and nuts
• Suits high current 12V and 24V setups
• Ideal for towbar, canopy and trailer plugs
• Grey plastic body with integrated bracket
• Attaches directly to Anderson housing
• Compact profile for drawers and battery boxes

Q: Does this handle replace the Anderson connector body?

No, this handle bolts onto an existing Anderson style connector. You keep your current plug and add the handle using the supplied screws. The handle clamps to the housing without changing the electrical contacts. This keeps your wiring layout the same while adding a better grip point.

Q: Can I use this handle on extension leads as well as fixed mounts?

Yes, it suits both styles of setups. Many people fit the handle to connectors on portable fridge leads or inverter cables. Others bolt it to plugs that sit near a towbar or canopy wall. As long as the connector is the correct 175 Amp or 350 Amp style, the handle can be fitted.

Q: Is any extra hardware needed for installation?

No, the required mounting screws come with the handle. You just align the bracket with the holes in the Anderson housing and tighten the screws. A basic screwdriver or small socket set is usually all that is required. No drilling into the connector body is needed.

Q: Will this handle work with other connector sizes?

It is intended specifically for 175 Amp and 350 Amp Anderson style housings. Smaller 50 Amp housings use a different footprint. Using the right size handle keeps the grip aligned with the connector shell. That helps avoid twisting loads on the plug and cable when you disconnect high current gear.

• Suits 175 Amp Anderson style connectors
• Suits 350 Amp Anderson style connectors
• Attaches directly to connector housing using supplied screws
• Suitable for use with Anderson style power leads and extension setups