This GME small rubber washer suits TX3400 and TX3520 head mounting setups where the bracket takes a lot of vibration on corrugated roads. The washer drops between the radio head bracket and the fixing hardware so the load spreads across a wider face. That helps the head stay steady when you tackle shire roads or long gravel runs and need the mic and display to hold position. The washer uses solid rubber so it can flex a bit without crushing and it fits straight onto the standard TX3400 and TX3520 head mount hardware. You can throw it in the spares kit as a smart buy if your current washer is starting to flatten or crack. The simple shape means you swap it out with basic hand tools in the shed or at camp and then get out there again.

• Genuine GME radio accessory component
• Small rubber washer for head mounting
• Suits GME TX3400 radio head brackets
• Also suits GME TX3520 radio head mounts
• Rubber construction cushions mounting hardware
• Helps maintain stable head position on brackets
• Ideal replacement for worn or lost washers
• Supplied as a single washer only
• Compact size suits tight under-dash installs
• Simple part to keep comms gear secure

Q: Is this washer sold individually or in a multi-pack?

This washer is supplied individually as a single piece. That suits replacing one damaged or missing washer on a TX3400 or TX3520 head mount. If you want spares for multiple vehicles you can add extra units to your order. Keeping a few in the toolbox is handy for quick radio swaps or bracket changes.

Q: Can this washer be used on other GME radio heads?

This washer is listed to suit TX3400 and TX3520 head mounting only. Other GME radios may use different hardware sizes or shapes. If the head mount uses the same style washer it may fit but check your existing hardware first. Matching the original washer size is the safest way to avoid loose mounts.

Q: Do I need any special tools to change the washer?

No special tools are normally needed beyond the correct screwdriver or spanner for your mounting screws. You simply remove the fixing, swap the old washer for the new rubber washer, and refit the hardware. Always tighten the mount evenly so the radio head sits straight on the bracket. Recheck the fixings after your first few drives on rough roads.

Q: Is this washer suitable as a long-term replacement or just a temporary fix?

This washer is suitable as a long-term replacement part. Rubber is commonly used in radio and accessory mounts because it compresses slightly and holds tension. As with any rubber part it can age over time so an occasional visual check is worthwhile. Swapping it out early helps keep the radio head stable and reduces strain on the bracket.

• Suits GME TX3400 radio head mounting
• Suits GME TX3520 radio head mounting
• Intended as replacement washer for head mounting hardware
• Fitment location: Radio head mounting point