This GME large flush mount bracket locks a GX400 or GX700 into place so the radio sits clean with the dash instead of hanging off a bracket on the side. The frame covers cut edges in panels around the helm or 4WD console so the finish looks tidy even on thin sheet. You get a stable mount point that keeps the set steady when the track or swell starts to kick up. The housing is solid moulded plastic with enough depth to take the full chassis of a GX400 or GX700 without stressing the case. Four screw points spread load so the panel is less likely to crack around the cut-out. The white finish lines up well with standard marine and RV trims that cop plenty of glare. If you want a neat flush setup for that specific GME gear this bracket is a smart buy.

• Large flush mount bracket for radios
• Suits GME GX400 and GX700 units
• White finish for clean fascia look
• Rigid plastic housing for stability
• Multiple screw points for firm mounting
• Frames cut-out edges for neat install
• Suitable for marine and 4WD cabins
• Supplied with matching mounting screws
• Classified as a radio accessory
• Genuine GME accessory for GX series

Q: Does this bracket come with the radio included?

No, this bracket is supplied on its own without a radio. You use it with an existing GME GX400 or GX700 unit. The kit is for mounting only and does not replace the radio body or microphone. Make sure you already have a compatible radio before ordering this bracket.

Q: Can I use this bracket with other GME radio models?

This bracket is specified to suit GME GX400 and GX700 radios only. Other models can have different chassis sizes or mounting points. Using it with non-listed sets can lead to poor support or gaps around the fascia. Stick with the stated models for a proper fit.

Q: Is the bracket suitable for marine and 4WD use?

Yes, the bracket is suitable for both marine and 4WD cabins when installed correctly. The rigid plastic body and metal screws handle vibration from corrugated tracks and boat slaps. Mount it on a solid panel to prevent flex. Keep the bracket in a reasonably sheltered location to minimise UV exposure.

Q: Are mounting screws supplied with the bracket?

Yes, a set of mounting screws is supplied with the bracket. The screws secure the frame to the panel and hold the radio in position. You may choose to use different hardware if your panel material needs specific fasteners. Always check length and thread type against your mounting surface before fitting.

This large flush mount bracket suits GME GX400 and GX700 radios only. The bracket is intended for panel or dash flush mounting where a rectangular cut-out is available. Installation requires access to the rear of the mounting surface so the bracket can be secured with the supplied screws. Mounting location should allow clearance for the full depth of the GX400 or GX700 chassis and cable connections.