Grab this GME DIN mounting cradle when you want the TX2720 or TX4500 sitting solid in the dash instead of wedged under the seat. The bracket lines up with a standard single DIN opening so the radio face sits neat with the rest of your gear. The steel frame stops the unit shifting when the track turns rough and keeps the mic lead clear of gear sticks and console switches. The cradle runs a formed steel shell with side plates that clamp into the DIN slot and spread the load across the dash. The front trim frame squares up to the radio body so you keep a clean line of about a single DIN worth of kit across the console. The mounting ears give you solid anchor points for fixing into metal or aftermarket fascia panels so you can get out there with a tidy communications setup.

• DIN size mounting cradle
• Suits GME TX2720 radios
• Suits GME TX4500 radios
• Bracket only supplied
• Fits standard single DIN apertures
• Supports secure in-dash radio mounting
• Metal frame construction for strength
• Front surround for neat dash finish
• Side mounting ears for fixing points
• Ideal for 4x4 and touring communication setups

Q: Does this cradle include the GME radio?

No, this cradle is the bracket only. The kit is meant as an add-on for existing GME TX2720 or TX4500 radios. You order the radio body separately to this mounting gear. This keeps costs down if you are just changing how the radio is fitted. It also means you can move an existing set into a vehicle DIN slot without buying a full new setup.

Q: Can I use this cradle with other radio models?

It is made to suit GME TX2720 and TX4500 models. The mounting pattern and opening size match these specific GME radios. Other radios may not line up with the side holes or front opening. If you run a different model, check for a cradle listed specifically for that gear. Mixing brackets and radios can lead to loose fits or fouled controls.

Q: Where is this cradle normally installed in a vehicle?

It installs into a standard single DIN dash or console slot. Most factory or aftermarket head unit openings use the DIN standard. This cradle slides into that space and anchors off the sides. Once fitted, the radio face should sit close to flush with the trim. This keeps the radio easy to see and reach while keeping the cabin tidy.

Q: What extra hardware might I need for fitting?

You may need screws or fascia adapters to suit your dash. The cradle brings the metal frame only, without vehicle specific screws or plastic trims. Many aftermarket fascia kits include screw points that line up with the cradle ears. If your dash has been modified, a fitter may add small brackets or nuts and bolts. Checking the dash layout before starting saves time on install day.

• Fits standard DIN size radio apertures
• Suits installation of GME TX2720 radios into DIN slots
• Suits installation of GME TX4500 radios into DIN slots
• Mounts radio body within vehicle dash or console DIN opening
• Additional mounting hardware may be required to suit specific vehicle dashes