This GME 1960mm Antenna Whip steps in as a straight replacement when the original whip on your UHF setup cops a hit. The fibreglass radome at 1960mm combines with 8.1dBi gain to help your radio reach further across open country and long highway runs. The whip suits the AS004B base assembly so it slots into existing GME bar mounts on many touring rigs without changing brackets. This kit runs a black fibreglass radome that handles sun and road grime on daily drives and big trips. The 1960mm one-piece build means no extra joints to rattle loose on corrugations. The 8.1dBi gain concentrates the signal for better coverage where terrain is mostly flat. Match it with your existing GME AS004B base and UHF so you can get out there and tackle long hauls with gear that makes sense for Aussie conditions.

• Replacement fibreglass antenna whip in black
• Suits GME AS004B base assembly
• Overall whip length of 1960mm
• Rated antenna gain of 8.1dBi
• Fibreglass radome construction for durability
• Single-piece whip design with no joints
• Intended for GME UHF communication setups
• Ideal for highway and open-country touring
• Supplied as whip only without base or mount
• Compatible with existing AS004B bar or bullbar mounts

Q: Does this antenna whip include the base or mount?

No, this antenna whip does not include a base or mount. This gear is supplied as the whip only so it suits setups that already have a compatible base on the vehicle. You keep your existing AS004B base assembly and hardware on the bar or bracket. Swapping just the whip can save money and keep your wiring untouched. Always check your current base model before ordering.

Q: What base assembly is this whip compatible with?

This whip is compatible with the GME AS004B base assembly. The thread and connection are matched to that specific GME base so the whip locks in correctly. Using the right base helps maintain the rated 8.1dBi gain and UHF performance. If your current antenna uses a different base code you will need to confirm compatibility. Matching components avoids poor connections and water ingress.

Q: Is this antenna whip suitable for low-roof garages and carparks?

The 1960mm length may be too tall for low-clearance areas. With almost two metres of height on top of your bullbar or bracket the whip can strike low beams or branches. Many drivers remove the whip when they know they will use tight city carparks. Others mount it lower on the bar to reduce overall height. Always measure your total vehicle height with the whip fitted.

Q: Can I use this whip in place of shorter GME whips on the same base?

You can use it if your base is the AS004B model. Different whip lengths give different gain patterns so this 8.1dBi option suits more open country. When you change from a shorter whip the radio characteristics will change. Some drivers keep two whips to swap between scrub and highway use. Always power the radio down before changing the whip.

• Whip suits GME AS004B base assembly only
• Intended as replacement whip for compatible GME UHF antenna setups
• Check existing base model (AS004B) before purchase