GME’s 1050mm Antenna Whip is a straight swap for a tired or broken whip on an AS004 base, with a solid 1050 mm of height and 6.6 dBi gain for those long UHF chats on open roads. The white fibreglass radome stands out cleanly on bullbars and mirror mounts, giving your touring setup a tidy, practical finish without changing your current base or cabling.

The whip runs a total length of 1050 mm, which pairs well with the 6.6 dBi gain to push signal out across flats and gentle rolling country. The fibreglass radome shrugs off typical road grime and light impacts better than bare metal, making it a smart buy for regular use. Matched to the GME AS004 base assembly, this kit keeps your UHF gear consistent and ready to get out there again.

• Replacement white fibreglass UHF antenna whip
• Whip length measures 1050mm for added height
• 6.6dBi gain suits highway and open-country use
• Radome constructed from durable white fibreglass
• Directly suits GME AS004 base assembly
• Whip-only supply lets you reuse existing base
• Suitable for UHF communication setups on vehicles
• Ideal for refreshing damaged or worn antenna whips
• Brand: GME
• Colour: white to match many vehicle setups

Q: Does this antenna whip include the AS004 base assembly?

No, this whip suits an existing AS004 base assembly but does not include the base. You keep your current base and coaxial cable in place on the vehicle. You then remove the old whip and thread this replacement whip onto the AS004 base. This keeps the swap quick and cuts down on extra hardware.

Q: What UHF use is a 6.6dBi whip suited to?

A 6.6dBi whip suits open highways and flatter touring country. The higher gain flattens the radiation pattern to push more signal out towards the horizon. This helps when convoy vehicles spread out over several kilometres. In tight hills or heavy forest, a lower-gain whip may sometimes perform better.

Q: Is the whip suitable for bullbar mounting when used with an AS004 base?

Yes, when fitted to an AS004 base, the whip works on typical bullbar or mirror mounts that match the base. The 1050mm length gives good clearance above most ute and wagon roofs. The fibreglass radome handles wind drag from highway speeds. Always check your total height against low-clearance carparks and garages.

Q: Can I use this whip with non-GME bases?

The whip is specified to suit the GME AS004 base assembly. Thread size and electrical match are set up for that base. Using other bases risks poor contact or mismatched tuning. For best performance and reliability, pair it only with the AS004 base listed in the specs.

• Suits GME AS004 base assembly
• Replacement whip for compatible GME UHF antenna bases
• Requires existing or separately purchased AS004 base for installation
• Suitable for UHF communication setups that accept AS004-compatible whips