The GME 465mm Antenna Whip (Cellular) - Black is a straight swap when you have a busted cellular whip on the bar that was around 465 mm long. The fibreglass build keeps it light so it does not hammer the mount on corrugations where tyre pressures drop to about 18 psi. The compact length sits well under a common 2.1 m carpark limit on most 4WD tourers.

This bit of gear runs a fibreglass core and tough outer jacket so it holds up on trips where daytime temps hit 35°C plus and the rig still sits on 100 km/h highway speeds. The black finish matches most bar work and aerial brackets up to around 50 mm wide, so it does not stand out across the roofline. For anyone who wants their cellular antenna working again without swapping the whole base, this whip is a smart buy.

• Replacement cellular fibreglass antenna whip
• Overall whip length is 465mm
• Suits existing compatible cellular bases
• Compact length helps with low clearances
• Fibreglass construction keeps weight low
• Black outer finish for a clean look
• Intended for cellular communication use
• Ideal when original cellular whip is damaged
• Simple swap for existing threaded mounts
• GME branded communications accessory

Q: Is this whip a complete antenna kit with base and cable?

No, this is a replacement whip only. This gear is meant to screw onto an existing compatible base that already has cable run into the vehicle. It suits situations where the original fibreglass section has been snapped or worn. If you do not already have a base and cable, you will need those as separate parts from your installer.

Q: What type of signal does this antenna whip support?

This whip is for cellular communications. It is built as part of a cellular antenna setup used with mobile phone coverage equipment. The length and construction are suited to common cellular frequency bands. It is not intended as a UHF CB or AM/FM radio antenna.

Q: Can I cut the whip shorter to suit my vehicle height?

Cutting the whip is not recommended. Shortening a tuned fibreglass antenna section can change its performance on cellular bands. Any modification may reduce signal effectiveness and could affect how the base loads the antenna. It is better to choose a whip that already matches the required length.

Q: Is this whip suitable for mounting on a bull bar?

Yes, when used with a compatible base. The 465mm length works well on bull bar mounts where overhead clearance matters. The compact size reduces leverage on the bracket on rough roads. Always ensure the base and bracket are rated for the antenna and fitted by a competent installer.