This GME 4.5 m auto antenna lead assembly hooks your AEM4 auto antenna to the radio with a single RG58 coax run. The 4.5 m length gives enough reach for most ute and wagon cabins without a bunch of excess cable to stash behind the dash. The PL30N auto antenna connection locks onto the AEM4 base with a screw style setup so you can tackle corrugated tracks without chasing loose plugs. The lead uses RG58 coax which is standard radio gear and proven for vehicle antenna runs of around 4.5 m. The screw type auto antenna connector sits in metal and plastic housing built tough enough for normal Aussie touring use. The opposite end uses a standard auto antenna plug that matches most car head units on the market. If you already rate GME for radios this is a smart buy to keep the setup matching end to end.

• GME 4.5 m auto antenna lead assembly
• RG58 coaxial cable for radio applications
• PL30N auto antenna connection at antenna end
• Screw type connector suits GME AEM4 antennas
• Standard auto antenna plug for head unit connection
• Single piece lead assembly supplied pre-terminated
• Length suited to typical ute and wagon installations
• Classified as a radio accessory for communications setups
• Black cable sheath for low profile interior routing
• Supplied as lead assembly only with no extra fittings

Q: Is this lead assembly compatible with antennas other than the GME AEM4?

This lead assembly is specified to suit the GME AEM4 auto antenna. The PL30N connection and screw type fitting are matched to the AEM4 base hardware. Other antennas may use different thread patterns or connector styles. For non AEM4 setups it is best to match the connector type and thread spec before buying.

Q: Does the cable come pre-terminated at both ends?

Yes this lead assembly is supplied pre-terminated. One end carries the PL30N auto antenna screw connector and the other end carries the standard auto antenna plug for the head unit. This means there is no soldering or crimping required on the supplied assembly. You simply route the 4.5 m cable and connect each end.

Q: Can this 4.5 m length be shortened if it is too long for my vehicle?

The lead is supplied as a finished 4.5 m assembly and is not intended to be shortened. Cutting the RG58 coax or removing the factory connectors can affect performance and reliability. If a shorter length is needed it is better to choose a different factory length if available. Modifying the assembly may also affect any manufacturer support.

Q: Is this lead suitable for use in marine environments?

The lead is supplied as an auto antenna accessory and is specified for automotive use. Standard RG58 coax and metal connectors can be used in cabins or protected areas on some boats if installed correctly. Extra sealing and corrosion protection may be required in exposed marine environments. For regular saltwater use a marine rated assembly is usually the safer choice.

• Suits GME AEM4 auto antenna models using PL30N connection
• Screw type auto antenna connector for secure attachment to AEM4 base
• 4.5 m cable length suitable for typical vehicle radio to antenna routing
• Intended for use with automotive radio antenna installations