The GME 1.5mm Stainless Steel Bonnet / Boot Z Bracket gives you a simple way to mount an antenna off the bonnet or boot edge with a compact plate around 1.5 mm thick. The Z shape steps the antenna base roughly 20–30 mm out from the body panel so the whip clears guards and light brackets. The face carries a central hole sized for common antenna bases and two smaller holes for hardware. This bracket runs stainless steel plate noted at 1.5 mm and also referenced as 2 mm in the specs, with a stainless finish that stands up to wet tracks and salty air. The flat mounting face spreads load across the bracket so the antenna stays steady over thousands of kilometres on corrugations. The simple shape suits typical bonnet or boot lips where you want the mount fixed without a full bullbar setup. It is smart buy gear for everyday touring rigs.

• Bonnet / boot 'Z' shaped antenna mounting bracket
• Stainless steel construction for corrosion resistance
• Listed thickness of 1.5 mm in product name
• Features 2 mm stainless steel thickness in key features
• Stainless steel finish for tidy appearance
• Central antenna mounting hole plus two smaller holes
• Suits mounting on bonnet or boot edges
• Supplied as bracket only with no hardware
• Compact design for radio communication setups
• GME branded accessory for antenna installations

Q: Does this bracket include any mounting bolts or hardware?

No, this bracket is supplied as the bracket only. You can then choose bolt lengths and washers that suit your specific bonnet or boot panel thickness. This avoids forcing hardware that might be too long or too short for your vehicle. It also lets you match any existing stainless fasteners already on the vehicle.

Q: Can this Z bracket be used for different antenna brands?

Yes, it suits antennas that match the central hole size and mounting style. Most common UHF and AM radio bases use similar stud diameters, so the bracket works with a wide spread of gear. Just check the base thread and washer size before installation. If the base collar is larger than the central hole, an adaptor plate may be needed.

Q: Is the bracket suitable for coastal and marine exposed areas?

Yes, the bracket is made from stainless steel with a stainless finish. That material has much better resistance to rust than painted mild steel in salty or humid air. It still benefits from an occasional fresh-water rinse after beach or boat ramp use. Regular checks for trapped salt around fasteners will keep it in good shape.

Q: Can I fit this bracket without drilling large new holes in my vehicle body?

Often yes, as the Z shape is intended to clamp around an existing bonnet or boot edge. Many installers line up the bracket holes with existing mounting points or small pilot holes in easier-to-repair areas. Careful placement keeps the main body panels intact. Always confirm clearance for wiring and panel movement before tightening everything down.