This Coast to Coast gas hose runs 300mm between a 5/16" SAE MF fitting and a 3/8" BSP M fitting, so it slots straight into common caravan and camper LPG layouts. With a 6mm internal diameter and Class C rating up to 2600kPa, it handles standard LPG appliance loads without taking much space. You can set it up where a short flexible link keeps solid copper lines tidy near the bottle or regulator.

The Class C hose construction is rated from -20°C to +65°C, which covers cold high-country mornings and hot storage lockers across Australia. Brass ends on the 5/16" SAE and 3/8" BSP sides give a consistent seal on matching threads when tightened correctly. AGA approval number 4237 backs the hose for LPG (propane) duty, making it a smart buy for keeping your gas setup compliant and reliable.

• For use with LPG (propane) systems
• 300mm hose length for compact runs
• 5/16" SAE male flare inlet fitting
• 3/8" BSP male outlet fitting
• Class C gas hose construction
• Maximum working pressure 2600kPa
• Working temperature range -20°C to +65°C
• Hose internal diameter 6mm
• AGA approval number 4237
• Suitable for caravan and RV gas layouts

Q: Can this gas hose be used with LPG only?

Yes, this hose is specified for LPG (propane) use. The Class C rating, AGA approval 4237 and the fittings are all matched to LPG systems typically found on caravans and RVs. Use it with regulators and appliances that are rated for LPG and the same pressure range. Avoid using it with other gases unless they are clearly approved for this exact hose type.

Q: What pressure can this hose safely handle?

The hose is rated to a maximum working pressure of 2600kPa. This rating sits within Gas Hose Class C, which is common for caravan and RV LPG setups. Always ensure the regulator and appliance also fall under this pressure range. Do not exceed 2600kPa in normal operation to keep the hose within its tested limits.

Q: What temperature range is the hose suitable for?

The hose is specified for a working temperature range from -20°C to +65°C. This covers typical Australian conditions from cold mornings to hot storage spaces. Keep the hose away from direct flame and surfaces hotter than 65°C. Protect it from prolonged contact with ice or freezing liquids that may push it below -20°C.

Q: What thread sizes are on each end of the hose?

One end uses a 5/16" SAE male flare thread and the other end uses a 3/8" BSP male thread. This combination suits many caravan regulators and appliance inlets. Always check the stamped or labelled thread sizes on your existing fittings before ordering. Using the correct threads reduces the risk of leaks and avoids the need for extra adaptors.

Suitable for LPG (propane) gas connections where a 5/16" SAE male flare inlet must connect to a 3/8" BSP male outlet over a 300mm hose length. Use only in installations that match Class C hose rating of 2600kPa and -20°C to +65°C working temperature. Install according to relevant Australian gas standards and regulations with correct sealing methods for SAE and BSP threads.