This LV Automotive fused battery distribution block gives you 1 MEGA and 2 MIDI slots off the same battery post so you can run a main feed plus two accessory lines without extra junctions. The clamp mounts straight onto a standard battery terminal so you keep the wiring short and tidy. The bright red cover marks the positive side clearly so it is easy to spot when you lean over the guard. The housing and lid are solid plastic with enough depth to clear typical MEGA and MIDI fuse bodies and cable lugs. The studs are metal with nut and washer hardware so you can torque your ring lugs properly and forget about them. The layout suits common 4WD and boat setups where space around the battery is tight. If you want a smart buy for tidy high current distribution this little bit of gear earns its spot.

• Three-way fused battery distribution block
• Provides one MEGA and two MIDI fuse positions
• Supplied as housing and hardware only
• No MEGA or MIDI fuses included
• Clamp-on design mounts to battery terminal
• Suitable for 12V and 24V electrical systems
• Helps keep high current cables short and protected
• Red cover clearly identifies positive battery connection
• Ideal for 4WD, caravan, trailer and marine setups
• LV Automotive brand bolt-on fuse holder

Q: Are any MEGA or MIDI fuses supplied with this fused battery distribution block?

No, the block is supplied without fuses. This means you can choose MEGA and MIDI fuse ratings that actually suit your cable sizes and loads. It also avoids paying for ratings you do not need. Just match each fuse to the maximum current of its circuit. Always follow the recommendations from your electrician or auto sparky.

Q: Can this fuse block be used in both 12V and 24V systems?

Yes, it can be used in typical 12V and 24V automotive or marine setups. The actual voltage rating is governed by the MEGA and MIDI fuses you select plus the insulation of the connected cables. For most dual battery and boat systems this fits in fine. Make sure your total system voltage stays within the ratings of all components.

Q: Where should I mount this fused battery distribution block in my setup?

The block is intended to mount directly on the battery terminal. Placing it at the battery keeps the high current section short and protected. It also makes fault finding much simpler because all main fuses are in one place. Avoid mounting it where it can be submerged or physically damaged.

Q: Do I need any special tools to install this gear?

You will need suitable spanners for the clamp and stud nuts plus a proper crimping tool for cable lugs. Correctly crimped lugs reduce resistance and heat at each joint. Tight hardware also helps the fuses run within spec. If you are unsure about crimping or cable sizing get an auto electrician to set it up.

Suitable for use on batteries that accept a clamp-style terminal connection.

Accepts one MEGA style fuse and two MIDI style fuses for branch circuits.

Intended for 12V or 24V marine and automotive electrical setups using bolt-on fuse holders.

Install as close as practical to the battery positive terminal for overcurrent protection.

Use appropriately rated MEGA and MIDI fuses matched to cable size and load.

Ensure correct cable lugs and crimping tools are used for all terminations.