This Electro Parts maxi blade fuse holder with 6mm cable is the sort of simple gear that keeps higher draw circuits honest. You drop it into a 12V accessory line and the inline body gives you a clear spot for a maxi fuse sized to the load. The hinged cap stays attached, so when you are chasing a fault after 200 km of corrugations you are not hunting for loose covers in the tub. The housing runs a solid moulded plastic body with three screw points so you can bolt it to a board or guard panel between 3 mm and 10 mm thick. The red insulated 6mm leads suit typical accessory feeds where you want a bit more copper than light wiring gives. The internal metal contacts are shaped around the full maxi blade width so the fuse sits firm under vibration, which is a smart buy for touring setups.

• Brand: Electro Parts inline fuse holder
• Suits maxi blade style automotive fuses
• Supplied with attached 6mm red cable tails
• Hinged protective cap over fuse contacts
• Moulded black plastic housing and cover
• Metal internal contacts support maxi blades
• Three screw points for secure panel mounting
• Inline configuration keeps fuse close to circuit
• Ideal for higher draw 12V and 24V accessories
• Compact body suits battery boards and canopies

Q: Does this fuse holder come with a fuse installed?

No, the fuse holder does not include a fuse. You choose a separate maxi blade fuse to match the current rating of the circuit you are wiring. This lets you size protection correctly for a compressor, fridge, or other accessory. Always match the fuse rating to the cable size and load requirements of your setup.

Q: Can I mount this fuse holder to a panel or battery board?

Yes, the body has screw points for mounting. You can fix it to timber, plastic, or metal boards using suitable screws for the material. A firm mount stops the holder moving on corrugations. It also keeps the fuse location obvious when you need to check or replace it.

Q: What style of fuse fits this holder?

This holder is made for maxi blade fuses. These are the larger plastic blade fuses often used on higher current circuits. The internal contacts are shaped to suit the wider blades of this format. Standard smaller blade fuses do not locate correctly in this style of holder.

Q: Is the cable already attached to the holder?

Yes, the 6mm cable tails are factory attached. That means you only need to join each tail into your positive feed and load side using your preferred crimp or join method. Pre-attached tails keep the number of joints near the fuse to a minimum. This helps maintain good continuity through the protection point.