The Frilight Cirro ceiling light gives your 12V caravan or RV a straightforward way to brighten a small living space with a single 10W halogen globe. The surface mount body sits only 48mm high and spans 250mm across so it works well on low ceilings where headroom matters. The built in switch means you can control the light right at the fitting without chasing wall wiring. The white housing and opaque lens throw a soft spread of light across a 250mm diameter zone instead of a tight hot spot. The opaque lens also hides the halogen globe so the setup looks tidy even in small dinettes or bunk areas. The 12V 10W spec keeps power draw predictable alongside your other caravan gear. If you want simple ceiling lighting that just works this is a smart buy.

• Surface mounted 12V halogen ceiling light
• Suitable for caravan and RV interiors
• Uses a 10W halogen globe
• Integrated on-body switch for control
• White housing suits standard ceiling finishes
• Opaque lens reduces glare from the globe
• Circular body with 250mm diameter footprint
• Overall dimensions 250mm(L) x 48mm(H) x 250mm(W)
• Low 48mm profile helps preserve headroom
• Simple surface mount design for flat panels

Q: Can this light be used in both caravans and motorhomes?

Yes, it can be used in any suitable 12V interior space. The unit only needs a stable 12V supply and a flat mounting surface large enough for the 250mm diameter base. Many caravans, motorhomes, and camper conversions already run 12V lighting circuits. Just match the wiring and protect the circuit with an appropriate fuse.

Q: Is the halogen globe replaceable if it fails?

Yes, the 10W halogen globe can be replaced. The opaque lens can be removed following normal light fitting practice to access the globe inside. Using the same 12V 10W rating keeps heat and power draw within the original design. Always isolate the 12V supply before working on the fitting and check polarity when reconnecting.

Q: Does the light need a wall switch or separate control?

No, this fitting has an integrated switch on the body. The built in switch means the electrician only needs to bring a suitable 12V feed to the light position. Users then control the on and off function directly at the fitting. This keeps wiring simple in compact vans with limited wall space.

Q: Can this ceiling light be dimmed with a standard 12V dimmer?

It may be used with a compatible halogen rated 12V dimmer if installed by a competent person. The dimmer must suit the low 10W load to avoid flicker or poor performance. All connections should follow the dimmer manufacturer instructions. If you are unsure a licensed installer can confirm the best control option for your setup.