If you are loading a Toyota Landcruiser 200 with bar work and a winch the Fox 2.0 Performance Series front coilover is the sort of gear that keeps the front end sitting right with around 3 inch of lift and a practical 0–2 inch ride height window. The 2.0 inch body and heavy to extra heavy duty coil handle the weight so you can tackle corrugations and station tracks without the nose sagging into every washout.

The aluminium shock body and IFP smooth body design keep the oil and gas separated so damping stays consistent when the temperature climbs on long dusty days. The coil rate is aimed at constant accessory weight over the front axle not a bare wagon so it is a smart buy if your 200 has steel barwork fitted. Match this coilover with quality rear suspension and the whole setup is ready for big Australian distances.

• Fox 2.0 Performance Series front coilover
• Suits Toyota Landcruiser 200 Series 2007-on
• Front position coil-over IFP smooth body shock
• Heavy–extra heavy duty front coil spring
• Provides approximately 3 inch front lift
• Usable ride height range stated as 0–2 inch
• 2.0 inch diameter aluminium shock body construction
• Intended for vehicles with constant front accessory load
• Ideal for touring setups with bars and winch
• Part of Fox 4x4 and touring suspension range

Q: Will this Fox 2.0 Performance front coilover fit all Toyota Landcruiser 200 models from 2007-on?

It is intended for Toyota Landcruiser 200 Series from 2007-on. Different trim levels and accessories change front axle weight and available travel. If your 200 has aftermarket bar work or engine accessories the heavy–extra heavy duty coil rate is usually more suitable than a light rate. Always confirm fitment against your VIN and existing suspension layout before ordering.

Q: What kind of lift should I expect with this heavy–extra heavy duty coilover?

The listed specification is approximately 3 inch of front lift. Actual ride height depends on your current suspension height and front accessory weight. Vehicles with steel bar work and a winch will typically sit lower than bare vehicles on the same coil. A wheel alignment after altering ride height is recommended to keep tyre wear and handling in check.

Q: Is this coilover intended for stock-weight Landcruiser 200s with no accessories?

The coil is rated heavy to extra heavy duty so it best suits vehicles with constant front load. On a stock-weight 200 the ride may feel firmer than a standard-duty coil and usable lift may be higher than needed. If your vehicle has no bar work or winch you may be better off with a lighter spring rate front setup. Always match spring rate to real front axle weight.

Q: Do I need any extra brackets or hardware to fit this Fox 2.0 Performance Series front coilover?

The coilover is built as a direct front replacement for compatible Landcruiser 200 models. Existing upper and lower mount locations on the vehicle are used during installation. Old hardware should be inspected and replaced if worn while the suspension is apart. A qualified suspension workshop can supply any additional nuts or bushes required during the job.

Parent SKU CO016 indicates other front coilover options for Toyota Landcruiser 200 2007-on, with different spring rates or lift heights under related variants.

Suitable for Toyota Landcruiser 200 Series from 2007-on with front suspension converted to Fox 2.0 Performance Series coil-over IFP shocks. Front coilover provides approximately 3 inch lift with a stated ride height range of 0–2 inch. Heavy–extra heavy duty coil spring rate suits vehicles with significant constant front load. Professional installation and wheel alignment are recommended after fitment.