The Camec Flange 3/4" - 19mm Rail Oval Shape holds a 19 mm coffee tray rail steady so your table setup stays in line. The oval base gives you two fixing points, so the rail does not twist every time someone leans on the tray. The gear suits caravan and RV furniture where a compact rail support is needed on narrow benchtops.

Steel construction with a chrome plated finish means this flange shrugs off the knocks and scuffs that come with touring Australia. The 19 mm bore matches standard 3/4" rail used in many coffee trays, so the tube sits snug with little slop. Two screw holes take common small fasteners to bite into plywood or particleboard. It is simple, proven hardware that keeps your tray gear working trip after trip.

• Camec steel flange for coffee tray rails
• Suits 3/4" / 19 mm round rail
• Oval base provides two mounting points
• Chrome plated finish for clean appearance
• Intended for caravan and RV furniture use
• Helps keep coffee tray movement aligned
• Compatible with standard screw fixings (not included)
• Compact footprint suits narrow tables and benches
• Steel body offers solid support for everyday loads
• Simple replacement part for worn or missing flanges

Q: Does this flange fit all 3/4" coffee tray rails?

It fits standard 3/4" (19 mm) round rails. As long as your rail is a true 19 mm outside diameter, it will sit correctly in the bore. If the tube is smaller or larger, you may get looseness or may not be able to seat the rail. Always measure the outside of your existing rail before ordering.

Q: Do I get mounting screws with this flange?

No, mounting screws are not included. This lets you choose fasteners that suit your table or cabinet material, like timber, ply, or composite board. Using the right length and thread type stops pull-out over time. Always pre-drill pilot holes so the board does not split when you fit the screws.

Q: Can I use this flange in other furniture areas of the van?

Yes, you can use it anywhere a 19 mm rail needs a support point. Many people use similar flanges on wardrobe rails or light-duty hand rails. Just remember it is intended for coffee tray and light furniture loads. Heavy grab rails or structural supports need hardware rated for higher loads.

Q: Is the chrome finish suitable for humid caravan interiors?

Yes, the chrome plated steel is suitable for normal indoor caravan humidity. The finish resists surface rust better than bare steel in typical van use. Wiping off spills and condensation will help keep the surface looking tidy. Avoid harsh cleaners or abrasives so the chrome layer stays intact.

• Suits 3/4" / 19 mm coffee tray rails in caravans and RVs
• Oval base with two mounting holes to fasten to table or cabinetry
• Flange bore sized for 19 mm round rail to locate and support the tube
• Commonly used on folding or slide-out coffee tray setups where rail support is required