The TAG Extra Long Towbar Hitch Pin steps in when a standard Class 4 pin will not reach through a LandCruiser 300 Series hitch and tongue. The bent arm gives you extra clearance over bulky hitch hardware while the 16 mm pin locks the towbar tongue in place. That means you can hook up heavier style tow setups and get out there without juggling spacers or half‑engaged pins.

The steel pin runs to about 110 mm of usable length from the bend, with a 48 mm drop so your hand can get under the bar to pull it. A 16 mm diameter shaft with 2 x 45° chamfers slides through Class 4 style receiver holes without fuss. The clip hole sits roughly 11 mm from the end so the supplied clip sits tight and resists movement when you tackle corrugations or sharp driveway angles.

• Extra long pull pin for Class 4 hitches
• Suits Toyota LandCruiser 300 Series towbars
• Offset design for better clearance under bar
• Approximate usable reach of 110 mm
• Drop of 48 mm for easier hand access
• 16 mm diameter pin suits heavy duty receivers
• 2 x 45° chamfers for smoother insertion
• Includes matching retaining clip for security
• Steel construction suited to towing duties
• Ideal spare or upgrade for factory pin

Q: Is this hitch pin only for the Toyota LandCruiser 300 Series?

It is specified as suitable for the Toyota LandCruiser 300 Series. The dimensions match Class 4 style heavy duty hitches used on that vehicle. If another vehicle runs the same style receiver and pin diameter it may also work. Always compare the 16 mm pin diameter and length to your existing hardware before use.

Q: What makes this pin "extra long" compared to standard pins?

This pin uses an offset arm of roughly 110 mm reach. Many standard pull pins are shorter and can struggle to pass through thicker hitch tongues. The extra length helps the pin clear wider or reinforced drawbars. That gives more thread through the far side of the hitch for the clip to sit on properly.

Q: Does this hitch pin affect the towing capacity of my towbar?

The pin is built for Class 4 style hitches which are typically used in higher capacity towing. The effective capacity is still limited by your vehicle and towbar ratings. Always stick to the lowest rating between vehicle, towbar and towball or hitch. Check your owner manual and compliance plates for the exact numbers.

Q: How should I look after this hitch pin between trips?

Store the pin and clip clean and dry when not in the towbar. A light wipe with an anti‑corrosion spray helps reduce surface rust, especially after beach use. Rinse with fresh water after salt exposure. Inspect the pin and clip for wear or bending before each towing job and replace if damaged.

Suitable for Toyota LandCruiser 300 Series factory-style Class 4 towbars that accept a pull pin and clip. Pin diameter is 16 mm and overall horizontal reach is 110 mm which suits many heavy duty hitch receivers that require an extra long pin. Installation requires inserting the pin through the towbar tongue or hitch shank and securing with the supplied clip. No additional brackets or wiring are required for fitment.