This Coast to Coast copper pigtail kit links your LPG bottle to a double regulator with manual change over, using a fixed 450mm copper line and a POL connection at the cylinder. The other end runs a 1/4" inverted flare fitting, so it mates with common caravan gas regulators without extra adaptors.

The tube itself is copper over a full 450mm run, so it holds its shape across rough roads instead of flexing like rubber hose. Brass POL and 1/4" inverted flare ends give solid threads that stand up to repeated bottle swaps on trips. That combo makes this a smart buy for standard LPG setups on caravans, campers, and RVs that use manual change over regulators.

• Copper pigtail for LPG gas fittings
• Suits double gas regulators with manual change over
• POL connection to standard LPG cylinder valve
• 1/4" inverted flare connection at regulator end
• 450mm overall length for common caravan layouts
• Rigid copper tube helps maintain fixed routing
• Brass fittings support consistent thread engagement
• Suitable for caravan, camper, and RV gas setups
• Simple two-connection layout minimises leak points
• Part of Coast to Coast gas fittings range

Q: Can this copper pigtail be used on single cylinder setups?

Yes, it can be used on a single cylinder if the regulator has a 1/4" inverted flare inlet. The gear is listed as suitable for double regulators with manual change over, but the connection types are standard. As long as your regulator accepts a 1/4" inverted flare, the line will thread up. Always have gas work checked by a licensed gas fitter.

Q: What type of gas is this pigtail intended for?

This pigtail is intended for LPG cylinders with POL valves. The POL end matches the common Australian LPG cylinder outlet thread. The copper line is suitable for typical caravan LPG pressures. Use it within a compliant LPG installation and follow all relevant gas regulations.

Q: Does the 450mm length include the fittings?

The listed 450mm length refers to the overall pigtail length. This measurement covers the copper run as supplied for typical drawbar and locker layouts. Actual installed reach can vary slightly depending on how the tube is bent within its natural curve. Check your cylinder spacing before ordering if your setup is tight.

Q: Is this pigtail flexible like a rubber hose?

No, this is a rigid copper pigtail, not a flexible rubber hose. The copper can be gently formed to suit your layout but holds its shape once set. That reduces movement near the regulator and cylinder valves. It also helps keep the gas line away from sharp edges and hot components in the locker.

Suitable for connection between LPG cylinders and double gas regulators with manual change over that accept a POL fitting on the cylinder side and a 1/4" inverted flare connection on the regulator side.