This Coast to Coast teardrop LED assist handle pulls double duty on your caravan door with a grab handle and a daylight white 12V light in one unit. The front face comes in at around 235 mm high and 155 mm wide, so it sits neatly beside most RV doors without getting in the way. With IP67 water resistance it stands up to dust, rain and washing the van after a muddy run.

The rear mounting plate measures about 205 mm by 130 mm, giving plenty of bite for screws into the wall so the handle feels solid in the hand. A touch switch in the centre lets you run the LED without hunting for a separate switch after dark. The wired 12 V tails hook straight into your existing circuit, which makes this a smart buy for anyone keen to get out there with practical entry lighting.

• Coast to Coast teardrop LED assist handle
• Integrated daylight white LED entry light
• Suits 12 V DC caravan and RV systems
• IP67 water resistant housing for outdoor use
• Front face approximately 235 mm high
• Front width approximately 155 mm across
• Rear mounting section about 205 mm by 130 mm
• Touch switch on front for LED mode control
• White finish complements most caravan exteriors
• Pre-wired positive and negative leads on rear

Q: Can this assist handle be wired to an existing 12V caravan lighting circuit?

Yes, it can be wired into an existing 12V circuit. The handle includes positive and negative leads from the rear so it can share power with a nearby light or switch feed. Make sure the circuit has enough capacity for the extra load. Use proper joins and insulation to keep the connection secure on rough roads.

Q: Is the daylight white LED suitable for entry lighting at night?

Yes, the daylight white LED is suitable for step and doorway lighting at night. Daylight white output gives good contrast on steps and latches compared with softer warm tones. That helps you see edges and obstacles clearly when climbing in. It also works well with reversing or porch lights already fitted to many caravans.

Q: How much space do I need on the wall to mount this handle?

You need wall space at least 235 mm high and 155 mm wide. The rear mounting section is slightly smaller at about 205 mm by 130 mm, so the screws sit well inside that footprint. Check for internal framing or wiring before drilling the holes. Allow a bit of clearance above and below so your hand can grab the handle comfortably.

Q: Can this handle be exposed to rain while travelling or parked?

Yes, the handle can be exposed to rain while travelling or parked. The IP67 rating indicates a sealed body against dust and water ingress. That suits typical caravan use where road spray and storms are common. As with any exterior gear, check seals and mounting points occasionally, especially after long corrugated stretches.

This gear suits caravan and RV entry doors where a combined grab handle and light is required.

The setup mounts to a flat surface with screw fixings through the front face into the wall structure.

The kit wires into a 12 V DC supply using the pre-fitted positive and negative leads at the rear.

The equipment needs enough wall space for the 235 mm by 155 mm front footprint and 205 mm by 130 mm rear section.

The gear should be installed by someone confident with basic 12 V wiring and sealing exterior fittings.