This VES Cable Lug Bell Mouth in 70mm² is the bit you use when a hefty cable needs to land on an M8 stud without drama. The bell mouth entry helps guide the 70mm² conductor into the barrel so the strands do not bunch up as you prep the crimp. The flat tongue drops over an M8 post on things like bus bars, battery links or high-draw devices.

The lug is sized purely for 70mm² cable and an 8mm stud so you are not guessing on fit. The barrel length and wall thickness give you enough meat for a solid crimp with standard heavy-duty tools. The single-piece metal body gives consistent contact from cable barrel through to the M8 hole. Match it with quality 70mm² cable and correct heat-shrink and you have a smart buy for big current runs.

• VES bell mouth cable lug for 70mm² cable
• Sized specifically to suit M8 studs
• Bell mouth entry supports cable strands
• Flat tongue provides broad contact area
• Suitable for high current electrical connections
• Matches heavy 70mm² starter or winch cabling
• Solid metal construction for single-piece strength
• Compatible with standard heavy-duty crimp tools
• Ideal for marine and automotive bus bar links
• Works with heat-shrink for sealed terminations

Q: Do I need 70mm² cable for this lug?

Yes, this lug is sized specifically for 70mm² cable. Using smaller or larger cable can lead to a poor crimp and extra heat at the joint. Match the lug to the cable size stamped or printed on the insulation. If your cable is not clearly marked, measure carefully or check with an auto electrician.

Q: Will this cable lug fit any M8 stud?

It will fit standard M8 electrical studs and bolts. M8 refers to an 8mm diameter thread which is common on bus bars and battery hardware. Always check that the mating surface around the stud is flat so the lug tongue seats properly. Use matching M8 washers and nuts tightened to the correct torque.

Q: Is this style of lug suitable for marine wiring?

Yes, this cable lug is listed under marine electrical categories. It suits battery links, winch cables and main feeds where 70mm² cable is specified. For boat use, pair it with tinned or marine-grade cable if required. Seal the crimp barrel with adhesive heat-shrink to help keep out moisture and salt.

Q: What tool should I use to crimp a 70mm² lug?

Use a heavy-duty crimp tool rated for 70mm² lugs. Handheld hex or dieless crimpers and hydraulic crimpers are commonly used at this cable size. Select the die marked for 70mm² so the barrel compresses fully. After crimping, check that there is no cable movement in the barrel and finish with heat-shrink for strain relief.