This VES cable lug bell mouth 70mm² M10 stud helps you tie heavy cable into battery switches and busbars without messing around with undersized gear. The 70mm² barrel suits big current runs to winches or inverters, and the M10 tongue lands straight onto common marine studs. You get a clean, solid termination point that handles the day to day load of real trips. The bell mouth entry protects the 70mm² conductor as it feeds into the lug, which matters when the cable has to bend close to the terminal in cramped bays. The M10 hole lines up with standard hardware on battery posts and distribution blocks, so you can tackle upgrades without odd washers or adapters. For Aussie setups that push serious amperage, this is smart buy gear that just fits and works.

• Cable lug bell mouth style terminal
• Suits 70mm² electrical cable size
• Tongue drilled for M10 stud
• Suitable for marine and vehicle wiring
• Bell mouth entry supports cable insulation
• Flat pad provides solid contact area
• Works with standard heavy-duty crimp tools
• Ideal for high current battery connections
• Compact design fits tight electrical bays

Q: What cable size does this bell mouth lug accept?

This lug accepts 70mm² cable. The barrel is sized specifically around a 70mm² conductor so the crimp tool can compress the strands evenly. Using the correct size helps maintain current capacity along the whole run. It also reduces hot spots at the termination when the gear is under load.

Q: What stud size does the tongue fit?

The tongue suits an M10 stud. The clearance hole is set for standard M10 bolts and threaded posts found on many busbars and battery switches. Matching the correct stud size keeps the lug centred under the nut. That helps maintain even clamp pressure and a consistent contact patch.

Q: Where would I typically use a 70mm² M10 lug?

This lug suits heavy current circuits like large inverters or winches that run on 70mm² cable. The M10 tongue matches many high-current battery isolators and distribution posts. Using a lug that matches both cable and stud size helps keep voltage drop down. It also keeps the mechanical joint secure against vibration.

Q: Do I need a specific crimp tool for this lug?

You need a crimp tool rated for 70mm² lugs. A correctly sized hex or indent crimper compresses the full barrel and locks the strands in place. Undersized tools will not reach the metal all the way around. Oversized tools may leave the cable loose under the bell mouth.