This Brink diagonally detachable towbar bolts up under the Tesla Model Y and gives you a solid 50 mm ball mount for small trailers, bike racks and light camping loads. The detachable neck slots in on a diagonal axis so you can pull it out in a few seconds and get back to a clean rear bumper line and a departure angle close to the stock 26 degrees for steep driveways or gravel tracks.

The crossbar and side plates use high-tensile steel with wall thickness around 4 mm, tied into factory mounting points spread roughly 900 mm across the rear chassis. A black powder coat finish about 60–80 μm thick helps shrug off surface rust and stone chips on long highway runs. The 50 mm ball setup works with standard Australian towed gear, so you can hook up lighter trailers and carriers without chasing odd hardware.

• Suits Tesla Model Y (5YJY) from 03/2019-on
• Diagonally detachable towbar neck design
• Main bar tucks under rear bumper
• Standard 50 mm towball compatibility
• Steel crossbar and side plate construction
• Black powder-coated corrosion-resistant finish
• Uses factory chassis mounting points
• Provides towing and bike carrier capability
• Maintains near-original rear departure angle
• Ideal for light trailers and weekend touring

Q: Does this towbar fit all Tesla Model Y variants from 2019 on?

Yes, it is specified for Tesla Model Y (5YJY) built from 03/2019 onwards. Different trim levels share the same rear chassis pick-up points. As long as your vehicle is a Model Y with that build code and date range it will accept this bar. Always check the vehicle build plate before ordering.

Q: Can I remove the towball neck when I am not towing?

Yes, the neck is diagonally detachable. You can unlock it and slide it out, leaving the main bar tucked up under the bumper. This helps keep the rear of the car clean and reduces the chance of knocking shins in the driveway. It also keeps the towball out of the way for tight parking.

Q: Is the towball size compatible with Australian trailers?

Yes, the neck is built for a standard 50 mm ball. This size matches common Australian trailer couplings used on box trailers and many small camper trailers. That means you can hook up most light-duty hire or household trailers without swapping hardware. Always confirm your trailer coupling size before use.

Q: Can I use this towbar with a hitch-mounted bike rack?

Yes, the detachable neck gives you a ball mount that works with ball-mount style bike carriers. Many bike racks clamp over a 50 mm towball, which this neck provides. Check the rack and vehicle downball limits before loading up bikes. Do not exceed the lowest rated component in the setup.

Vehicle compatibility: Tesla Model Y (5YJY) built from 03/2019 onwards.