The B.E.S.T Water Filter Bracket kit gives you two plastic clips to hold an inline water filter solid against a cupboard wall or tunnel boot panel, so it is not rolling around once you hit 80 km/h on a corrugated road. Each bracket cradles the round filter body and keeps the hoses lined up with the existing 1/2 inch plumbing, which makes it easier to trace your setup when something needs checking.

The brackets use white plastic that shrugs off splashes and does not rust in damp under-sink spaces where temperatures usually sit between 5°C and 35°C. Each clip has a flat base with a single screw point sized for common 4 mm fixings, so you can bolt it into ply, chipboard or thin metal without special tools. The pack of 2 spreads the weight of a full inline filter so the setup can handle long trips on typical Aussie roads.

• Mounting clips for inline water filter
• Sold as a pack of 2 brackets
• Suits holding a single inline filter body
• White colour for tidy internal installs
• Plastic construction for corrosion resistance
• Flat base with central fixing hole
• Light weight for caravan and RV cupboards
• Helps stop filter movement on rough roads
• Simple clip shape cradles filter housing
• Compatible with B.E.S.T inline filter setups

Q: How many brackets are included in the B.E.S.T Water Filter Bracket pack?

The pack includes two brackets. This lets you support both ends of a single inline water filter so the housing cannot flex or sag. Using both clips gives the filter a solid mount on rough roads. It also helps keep the hose connections in line so they are less likely to be strained.

Q: What are the brackets made from?

The brackets are made from plastic. This material does not rust in damp cupboards or tunnel boots. It is also light, so it adds very little weight to your caravan or camper setup. Plastic is easy to drill or trim if you need extra clearance around existing fittings.

Q: Can these brackets be used in a caravan cupboard or under a sink?

Yes, they suit caravan cupboards and under-sink spaces. The flat base sits neatly on timber, laminate or thin metal panels. A single screw through each bracket is usually enough to hold an inline filter in place. The white finish also blends in well with most under-sink fittings.

Q: Do the brackets suit replacement of an existing inline filter mount?

Yes, they work well as replacement clips. If an old bracket has cracked, you can swap it for one of these without changing the filter itself. Just remove the old screws and refit with the new clips in the same spots. This keeps your existing hose routing intact and saves time.