The Axis HD Camera Extension Cable 6 m gives you another 6 metres of reach between an Axis HD camera and its monitor, handy on longer caravans and tray setups. The 4 pin connector at each end keeps power and video in one run over that full 6 m length, so your reversing or rear view camera can sit where it is most useful without shifting the monitor.

The cable runs a fixed 6 m length, which suits common ute, van and caravan layouts without leaving big loops of spare lead. Matching 4 pin plugs line up with Axis HD series monitors and cameras for a straightforward hook up, and the single sheathed run helps protect the internal conductors from typical Aussie dust and road grime. It is simple, reliable gear that does the job for camera extensions.

• HD camera extension cable for Axis systems
• Fixed cable length of 6 m
• 4 pin connector at each end
• Suits Axis HD series monitors
• Extends distance between camera and monitor
• Carries power and video in one loom
• Helps reach rear of long caravans or utes
• Simple plug in installation with matching plugs
• Black outer sheath for discreet routing
• Suitable for use with reversing and rear view cameras

Q: Can I join more than one Axis 6 m HD Camera Extension Cable in the same run?

Yes, you can connect more than one 6 m cable in series. Joining multiple 4 pin leads lets you stretch the run further along a caravan or truck. Just match each 4 pin plug and socket firmly so the connections stay seated. Keep the total length sensible to avoid messy coils behind panels. Secure the run with clips or ties to reduce movement.

Q: Is this cable only for rear view reversing cameras?

No, it can be used with any compatible Axis HD camera position. You can run it to side cameras on a caravan, a front camera on a bullbar, or a rear camera high up on a canopy. As long as the camera and monitor are Axis HD series with 4 pin connectors, the cable will carry their signal. The fixed 6 m length makes planning each run straightforward.

Q: Does the cable carry both video and power for the camera?

Yes, the 4 pin loom carries video and power together. The connectors are wired so the HD camera feed and its supply travel in a single 6 m jacket. That keeps the install cleaner than running separate power wires. Just plug straight into the Axis HD monitor harness. You still need suitable power at the monitor end of the system.

Q: Can this 6 m extension cable be routed outside the vehicle?

It is best routed in protected areas like chassis rails or interior trims. The outer sheath can handle normal vehicle use but it is not a heavy armour. Running it inside panels or conduit gives better long term protection from stone strikes. Avoid tight bends that pinch the 6 m run. Simple routing care helps the cable last longer on rough roads.

Cable suits Axis HD series monitors that use a 4 pin connector interface. Cable extends the distance between a compatible HD camera and its HD monitor by 6 m. Installation requires mating each 4 pin connector to an existing Axis HD camera lead and monitor input. Routing path must allow for at least 6 m of cable length without sharp bends.