This LV Automotive Anderson Plug Cover 50 Amp Red drops straight over a standard 50 amp Anderson style connector so you can throw gear in the tub without worrying about exposed contacts. The hinged lid closes over the plug face and keeps metal tie downs or fridge slides from leaning on the terminals under load. The bright red body stands out beside grey connectors so you can spot your power point fast at camp.

The housing is moulded plastic sized around the normal 50 amp Anderson footprint that most touring setups already run on 12 volt and 24 volt circuits. Polarity marks are built into the body so you line the connector up the same way every time when you bolt it down. Smooth edges help keep nearby cable sheathing tidy when the loom exits the rear of the cover. It is simple, solid gear and a smart buy for busy tubs and trailers.

• LV Automotive Anderson plug cover in red
• Suits standard 50 amp Anderson style connectors
• Adds protective barrier over contact face
• Hinged lid allows quick open and close
• Suitable for 12V and 24V DC circuits
• Bright red colour improves visibility in tubs
• Smooth housing edges help protect cable sheath
• Moulded polarity markings aid plug orientation
• Compact design suits trailers caravans and canopies
• Ideal for busy storage areas with loose metal gear

Q: Will this cover fit any 50 amp Anderson style plug?

Yes, it suits standard 50 amp Anderson style connectors. The housing is shaped around the common rectangular 50 amp body used in most touring and trailer setups. If your connector matches the usual grey 50 amp size, it will sit inside the cover. Oversized or non-standard high-current connectors will not seat correctly.

Q: Can I use this cover on both 12V and 24V systems?

Yes, it is suitable for both 12V and 24V DC setups. The cover does not change voltage or current ratings; it simply adds a physical barrier over the contact face. It is commonly used on dual-battery, caravan and trailer circuits. Always match the connected Anderson plug and wiring to the correct system rating.

Q: Does the cover provide any strain relief for the wiring?

The cover mainly protects the contact face rather than acting as a full cable clamp. The smooth internal edges help avoid abrasion where the cable exits the connector area. For heavy or long cable runs, it is still best practice to support the loom with separate clips or ties. That keeps movement away from the plug body.

Q: Is the bright red colour useful for identification in a busy setup?

Yes, the red body makes the covered connector much easier to see against dark drawers or chassis rails. This helps you pick the correct Anderson outlet quickly when you have several runs on the same vehicle. Clear identification reduces mix-ups between dedicated fridge feeds, trailer power, or accessory lines. It also stands out well in low light around camp.