The Tycab 2mm Black Marine Cable 30M spool is straightforward gear for wiring 12V circuits up to 30m in one run. The 2mm conductor handles the lighter loads you see on cabin lights and small accessories on boats under about 7m. The black sheath keeps polarity clear when you run it beside red positive cable in standard twin layouts.

This cable uses a marine-suitable 2mm conductor wrapped in insulation that fits common 5mm cable glands and conduits. The full 30m spool means fewer joins across decks or along trailer chassis rails around 4m to 6m long. You can cut several short looms between 2m and 5m from one roll, which makes it a smart buy for workshop stock. Tycab gear has a solid name around Aussie sheds and marinas.

• Brand: Tycab marine cable
• 2mm conductor size for light loads
• Black insulation for negative or accessory runs
• Supplied as a 30m continuous spool
• Suitable for 12V marine and trailer wiring
• Works with common 5mm cable clips and glands
• Ideal for cutting multiple short custom leads
• Helps reduce joins across decks or chassis
• Simple colour coding when paired with red positive cable
• Practical workshop stock for general wiring jobs

Q: Can I cut the 30m Tycab 2mm Black Marine Cable into shorter lengths?

Yes, the 30m Tycab 2mm Black Marine Cable comes as a continuous spool that you can cut to the lengths you need. This makes it handy for wiring several short runs from one roll. Just use a proper cable cutter for clean ends. Finish each end with suitable crimp terminals to keep connections solid.

Q: Is this 2mm black marine cable suitable for 12V lighting circuits on a small boat?

Yes, this 2mm black marine cable is commonly used on low current 12V lighting circuits on smaller boats. The 2mm conductor size matches the light loads found on cabin or deck lights. Always match the cable size to the actual current draw. Protect each circuit with a correctly rated fuse at the supply end.

Q: Does the Tycab 2mm Black Marine Cable fit standard marine cable glands and conduits?

Yes, this cable is sized to suit typical marine glands and conduits that accept similar to 5mm overall diameter wiring. That makes routing through existing deck glands straightforward. Always check the gland rating against the actual cable diameter. Tighten glands evenly so the insulation seals without crushing the conductor.

Q: Can I use this 30m spool of 2mm black marine cable on a boat trailer wiring setup?

Yes, this 2mm black marine cable can be used on suitable low-current circuits on a boat trailer. The 30m length gives enough reach along most trailer chassis rails. Make sure the cable is supported along the frame and protected from stone impact. Seal joins and connectors to keep out road grime and moisture.