This Sam Allen 2 Pin CP Brass Connector Set lets you run a simple 12V/24V feed to deck lights or cockpit gear without loose tails hanging about. Two brass pins carry power for smaller loads like a LED deck light or livewell pump drawing a few amps over short leads. The screw-apart plug and socket keep the join tight, so the connection stays put when the boat hits chop. The body is solid brass with a chrome plated finish to stand up better around saltwater spray than bare mild steel fittings. The socket flange gives four mounting holes so you can bolt it to a flat panel with 4 mm fasteners and know it will stay in place. A small chain keeps the cap attached, so the contacts stay covered when not in use. It is simple, reliable gear and a smart buy for tidier marine wiring.

• Chrome plated waterproof brass construction
• Includes matching plug and socket set
• Rated for 12V and 24V electrical systems
• Two-pin layout suits simple circuits
• Screw-apart design for secure connection
• Socket supplied with protective cap and chain
• Flanged base with multiple mounting holes
• Suitable for marine lighting and electrical gear
• Compact form factor for tight panel spaces
• Ideal for low voltage deck or cockpit power points

Q: Can this connector set be used on both 12V and 24V circuits?

Yes, this connector set is rated for 12V and 24V use. That makes it suitable for most small boat and trailer wiring jobs that run off a 12V battery bank or a 24V twin battery setup. Just match the cable size and fuse to the load current. The two-pin layout is best for simple positive and negative runs.

Q: Is the connector suitable for exposed locations on a boat deck?

Yes, the connector is built as a waterproof brass plug and socket with a chrome plated finish. The cap and chain help cover the socket face when the plug is removed. For best results mount it on a flat surface where water can drain away. Always check the seal and contacts as part of routine boat maintenance.

Q: Does this set include both the plug and the socket?

Yes, this is sold as a matching plug and socket set. The plug carries the two pins and threads into the fixed socket body. The socket includes the mounting flange and protective cap assembly. This means you get everything you need at the connector end and only need to supply suitable cable and mounting hardware.

Q: What type of applications suit a 2 pin connector like this?

This 2 pin set suits loads that only need a positive and negative feed. Common uses include deck lights, work lights, small pumps and removable accessories. The screw-apart design is handy where the gear may be unplugged between trips. Keeping circuits simple like this can also make fault finding easier down the track.