This LV Automotive 19mm S/S Cable Clamp kit locks down 19 mm cable runs so they stay put over corrugations and rough tracks. A 15 mm wide stainless band and EPDM liner share the load across insulation instead of cutting into it. The 6.4 mm mounting hole lines up with common M6 bolts in canopies, trailers and engine bays so you can keep wiring neat and supported. Grade W3 stainless steel and EPDM rubber handle temperatures from -35°C to 100°C without giving up clamping force. Softened band edges and reinforced tips are a smart buy when you want wiring to last instead of rubbing through. A pack of 10 clamps gives enough gear to tackle a full run of lights, compressors or accessories. This setup suits real Aussie conditions with salt, mud and road grime in the mix.

• Internal clamp diameter of 19mm for common auto cable bundles
• 15mm wide stainless band spreads clamping force on insulation
• 6.4mm mounting hole suits standard M6 bolts or screws
• Grade W3 stainless steel construction for corrosion resistance
• EPDM rubber liner cushions cable and reduces vibration
• Softened band edges minimise risk of insulation damage
• Reinforced band tips resist distortion under bolt tension
• Operating temperature range from -35°C to 100°C
• Supplied as a pack of 10 matching cable clamps
• Suitable for wiring and hose retention in vehicles, trailers and canopies

Q: Can these LV Automotive 19mm clamps be used in marine or coastal setups?

Yes, the Grade W3 stainless steel band gives good corrosion resistance for marine and coastal use. The EPDM liner handles spray and moisture within the stated temperature range. You still need to rinse gear after salt exposure where possible. Solid mounting with stainless fasteners will give the best service life.

Q: What bolt size fits the 6.4mm mounting hole?

These clamps suit standard M6 bolts or screws. The 6.4mm hole gives a small amount of clearance around a typical M6 fastener. Using flat washers helps spread load on the reinforced band tips. Stainless or zinc-plated fasteners will best match the clamp life.

Q: Are these suitable for high under-bonnet temperatures?

Yes, the listed operating range is -35°C to 100°C. That covers most under-bonnet and engine-bay locations in Australian conditions. You should still avoid direct contact with exhaust components that run far hotter than 100°C. Good routing and heat shielding improve long-term cable protection.

Q: What cable outside diameter do these actually suit?

These clamps are sized for a 19mm outside diameter bundle. That can be a single heavy cable or several smaller wires taped together. The EPDM liner compresses slightly around the loom to keep a firm grip. For much larger bundles you will need the next clamp size up.