This LV Automotive 19mm cable clamp kit keeps wiring looms up to 19mm across tidy along chassis rails, bulkheads, and transoms. Each clamp runs a 15mm wide band so the cable sits supported instead of pinched at a single point. A 6.4mm mounting hole lines up with common bolts and self-tappers, so you can lock wiring down on trailers, boats, or canopy builds. Mild steel in the clamp body gives solid clamping force without flex once it is bolted through a 6.4mm fixing. EPDM rubber along the inner face cushions the cable and helps separate the 19mm loom from vibration and hard edges. The pack of 10 clamps suits a full run from battery to accessory gear, which makes it a smart buy for tidy wiring in Australian heat, dust, and salt air.

• Internal clamp diameter of 19mm
• Clamp band width measures 15mm
• Mounting hole sized at 6.4mm
• Mild steel construction for strength
• EPDM rubber liner cushions cables
• Suitable for wiring and cable protection
• Pack includes 10 matching clamps
• Fits flat mounting surfaces and panels
• Ideal for marine and automotive looms

Q: What cable size does this clamp suit?

This clamp suits looms around 19mm outside diameter. The measurement refers to the internal diameter of the clamp when closed. It works well for single heavy cables or bundled smaller wires that measure close to 19mm overall. For much smaller looms, a smaller clamp size will give a neater hold.

Q: What type of fastener should I use with the 6.4mm hole?

Any suitable screw or bolt with a shank close to 6.4mm can be used. Common choices include M6 bolts or appropriate self-tapping screws into metal or timber. Match the fastener material to your mounting surface. Always ensure enough thread engagement for a solid clamp.

Q: Can these clamps be used in marine environments?

These clamps can be used in marine wiring layouts. The EPDM rubber liner separates the cable from the mild steel strap. Fastener and surface corrosion protection will still depend on your hardware and preparation. Regular inspection is recommended in saltwater environments.

Q: How many clamps are in one pack?

One pack contains ten clamps. This quantity is usually enough for a short wiring run from a power source to a few accessories. For longer boats or caravans, plan your cable path and count fixing points before ordering. Buying in full packs keeps each install consistent.

• Suits cables or looms approximately 19mm outside diameter
• Suits fasteners sized to a 6.4mm mounting hole
• Suitable for marine and general electrical wiring layouts
• Intended for securing wiring and looms to flat mounting surfaces